Assembling the RAT Protection Panel

1.Insert the rat protection panel to the assembling hole on front side to the end.

2.If you have difficulty inserting the panel lift up the washer a little and insert it

IN CASE OF PUMP-DRAINED WASHER

Take out the cap-hose and connect the outlet-hose.

Be sure to join tightly the drain hose into the drain-outlet on the back of the machine.

Be sure to join tightly the drain hose into the drain-outlet on the side of the machine.

Install the drain hose in the position of about 90~100cm above the ground.

cap-hose

90~100cm

outlet-hose

CONNECTING THE DRAIN HOSE	(a)
After pressing the joint ring(a), insert the drain hose(b)
to drain direction.

(b)

•When a proper amount (one time does) of fabric softener is stored in the softener inlet,it is automatically put in at the last rinsing cycle.

•Do not use detergent, bleach or starch into the Softener Inlet.

•Using too much softener may produce

unsatisfactory results.

Don't pour softener more than 40 CC.

•Do not open the lid during the Spin Dry cycle.

If added too early, its effectiveness will decrease.

•Do not leave the softener into the Softener Dispenser for a long time.

Because softner became stiff.

1.Open the detergent box by pulling in the direction of the arrow as shown in the figure and then put the powder detergent in the detergent box.

2. Put in one-time amount of detergent evenly so the detergent may not brim over the box.

Detergent Device

Put the detergent in proportion to water level

Softener Device Softener baseline

CAUTION : If softener is stored over the above base line, it may flow down at any time.