INSTALLATION & MAINTENANCE
The User’s Manual is for common use.
Make use of the User’s Manual depending upon your washing machine model.
ENVIRONMENT
Leave some space
Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface, noise or vibration occurs. (Allowable is 1˚)
Adjust the legs for even placement.
Never install the washer near water.
Do not place the washer in steamy rooms or where the washer is directly exposed to rain.Moisture may destroy the electrical insulation causing an electrical shock hazard.
Avoid direct sunlight or heaters.
As plastic and electrical components are affected by direct heat,never place the washer near furnaces, boilers, etc. Do not place under direct sunlight.
LEVELLING • If the washer is not leveled with the ground, it makes the machine tremble more or be out of order. So, make sure that the washer is leveled properly.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF THE WASHING TUB.
•Open the lid of the machine, pour water into the tub up to the level just below the pulsator, and adjust the legs so that the pulsator is positioned at the center of the water as shown in the figure.
•Place the machine more than
10cm away from the wall.
• Adjust the legs on feet for levelling .
Loosen 
Lock
1. Adjust the side horizontally first and the front
in same direction ❷ next.
2. If the thread is not within the limit, adjust the height of
the legs.
CONNECTING THE WATER SUPPLY HOSE
1.Remove the adaptor from the water supply hose.
5.Connect the other end of the water supply hose to the inlet water valve at the back of the washer.
Screw the hose clockwise all the way in.
2.First,using a "+" type screw driver, loosen the four screws on the adaptor. Next,take the adaptor and turn part(b) following the arrow for gap about 5mm between them.
a
b
Screw the hose clockwise all the way in.
3.Connect adaptor to the water tap by tightening the screws firmly.
Then, turn part (b) following the arrow and put (a) and (b)together.
a
b
If the water tap is a screw type,assemble a water supply hose that fits to the
tap as shown.
4.Connect the water supply hose to the adaptor. Pull down the part (c) of the water supply
hose .When the part (c)is released, c the hose is automatically connected to the adaptor
making a 'click' sound.
NOTICE After completing connection, if water leaks from the hose, then repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square or too big,remove the spacing ring before inserting the faucet into the adaptor.
8