HOW TO PUT THE DETERGENT IN AND ADD THE FABRIC SOFTENER
1.Open the detergent box by pulling in the direction of the arrow as shown in the figure and then put the powder detergent in the detergent box.
2. Put in
Detergent Device | Softener Device |
Put the detergent |
|
in proportion to |
|
water level |
|
Softener Device |
|
Softener |
|
baseline |
|
• When a proper amount (one time does) of fabric | • Do not open the lid during the Spin Dry cycle. |
softener is stored in the softener inlet,it is | If added too early, its effectiveness will decrease. |
automatically put in at the last rinsing cycle. | • Do not leave the softener |
• Do not use detergent, bleach or starch into | into the Softener |
the Softener Inlet. | Dispenser for a long time. |
• Using too much softener may produce | Because softner |
unsatisfactory results. | became stiff. |
CAUTION : If softener is stored over the above base line, it may flow down at any time.
HOW TO CLEAN THE FILTER
1. Place a rag under the washer filter not to wet the floor. | (pump drained washer) |
2. Rotate the filter counterclockwise | 1.Place a rag under washer filter not to wet the floor. |
and pull out the filter. | 2.Turn the |
3. Remove dirts and rotate | 3.Take the filter out and |
the filter clockwise | remove dirts. |
until it locks in position. | 4. Reassemble in |
| reverse order. |
CLEANING THE FILTER NET Clean the filter net often to keep the washer clean.
1.Push the upper part of the filter and pull in.
2. Open the cover as | 3. Clean the filter. | 4. Close the cover and insert the |
shown in the figure. |
| lower part of the filter in the |
|
| basket first and then push the |
|
| filter with "click" sound . |
1. Push up and | 2. Remove the collected | 3. Clean the filter. | 4. Pull down the filter net. |
pull out the filter net. | lint from the filter net. |
|
|
|
|
|
|
10