![](/images/new-backgrounds/1237721/23772119x1.webp)
LEVELLING ● If the washer is not leveled with the ground, it makes the machine tremble more or be out of order. So, make sure that the washer is leveled properly.
●Adjust the height control legs to make eve.
Lock
Lock Nut
UNLOCK LOCK
Adjustable
Leg ![](/images/new-backgrounds/1237721/23772119xi5.webp)
![](/images/new-backgrounds/1237721/23772119xi6.webp)
Unlock
●After slightly lifting up the machine, rotate the adjustable leg
●After putting down the machine after adjustment.
UNLOCK LOCK
UNLOCK | LOCK | Lock | Unlock |
|
|
|
●Adjust the height and secure.
●Secure the lock nut by rotating it firmly.
●If the lock nut is not secured, the adjustable leg may be released.
Adjustment of height
If not leveled, adjust the legs to level the washer.
●Be careful not to put in your hand under the legs. (It may cause some injury)
Pull the handles located at the right and left of the front side and slide off.
Adjust the water drop mark to be in the red circle pulling back the machine slightly, and then, push it with a feet to fix.
Fix the handles by hand completely.
Waterdrop mark | Cause | How to level |
|
|
|
| The front part is | Level it by adjustable legs. |
| lower | |
|
| |
|
|
|
| The back part is | Adjust the height by using the adjustable rubber |
| lower | or prop at the back. |
|
|
|
| The left part is | Adjust the left part by using the adjustable legs |
| lower | at the front and the adjustable rubber at the back. |
|
| |
|
|
|
| The right part is | Adjust the right part of the washer by using the adjustable leg |
| at the front and the adjustable rubber at the back. | |
| lower | |
|
|
WATER SUPPLY CONNECTOR FILTER
1.Pull out the filter and wash well.
inlet water valve
2.Pull in the filter and connect the hose to the inlet water valve tightly.
3.Check if there is a leakage. Note to tighten up the connector.
9