CONNECTING THE WATER SUPPLY HOSE
1.Remove the adaptor from the water supply hose.
5. Connect the other end of the water supply hose to the inlet water valve 
at the back of the washer.
Screw the hose clockwise all the way in.
2. First,using a "+" type screw |
| ||
driver, loosen the four screws |
| ||
on the adaptor. | a | supply hose to the inlet water valve | |
Next,take the adaptor and | b | at the top of the washer. | |
turn part(b) following the arrow for |
| Screw the hose clockwise all the way in. | |
gap about 5mm between them. |
|
| |
3. Connect adaptor to the |
|
| |
water tap by tightening |
| If the water tap is a screw type,assemble | |
the screws firmly. |
| ||
a | a water supply hose that fits to the | ||
Then, turn part (b) | |||
b | tap as shown. | ||
following the arrow and | |||
|
| ||
put (a) and (b)together. |
|
|
4. Connect the water supply hose to the adaptor. Pull down the part (c) of the water supply hose .When the part (c)is released,
NOTICE After completing connection, if water leaks from the hose, then repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square or too big,remove the spacing
the hose is automatically connected to the adaptor making a 'click' sound.
c
ring before inserting the faucet into the adaptor.
8