Samsung WD90N644OOW/LE manual Operations, Control panel

Operations

Operations

Control panel

02
			11
08		09	10
			12
07
03	04	05	06

01	Cycle Selector	Turn the dial to select a cycle.
		The display shows current cycle information and estimated time
02	Display	remaining, or an information code when a problem occurs.
		For buttons and icons, refer to the corresponding page.
03	Temp.	Press to change the water temperature for the current cycle.
04	Rinse	Press to change the rinse count for the current cycle. You can set the
		rinse count to a max of 5, depending on the cycle.
		Press to change the spinning speed for the current cycle. The
		revolutions per minute (RPM) differs with the model.
		•	Rinse Hold(No indicator): The final rinse process is suspended so
			that the laundry remains in the water. To unload the laundry, run
			a drain or spin process.
			-  To use the Rinse Hold option, press Spin repeatedly until all
			rpm numeric indicators turn off. Not available for the DRAIN/
05	Spin		SPIN cycle.
		•	No Spin : The drum does not rotate after the final drain process.
			-  To use the No Spin option, press Spin repeatedly until the No

Spin () indicator turns on.

•Spin Only: To run the Spin Only cycle, press Spin for 3 seconds. When the cycle time and spinning speed appear, press Spin repeatedly until a desired spinning speed is selected. Then, press and hold Start/Pause (Hold to Start) to start the cycle. The spinning time depends on the selected cycle.

34  English

WD90N644OOW_03924L-00_EN.indd 34

2018/3/1 11:26:41