Positioning the drain hose

Installing the Washing Machine

Connecting the water supply hose

1. Remove the adaptor from the		4.	Connect the water supply hose to
water supply hose.			the adaptor. Pull down part (c) of
			the water supply hose.
	c		When you release part (c) the
			hose automatically connects to
			the adaptor making a‘click’ sound.
2. First, using a‘+’ type screw driver,		5.	Connect the other end of the
loosen the four screws on the			water supply hose to the inlet
adaptor. Next, take the adaptor			water valve at the top of the
and turn part(b) following the			washer.
arrow until there is a 5mm gap.			Screw the hose clockwise all the
			way in.
3. Connect adaptor to the water tap		•	If the water tap has a screw type
by tightening the screws ﬁrmly.			faucet, connect the water supply
Then, turn part (b) following the	a		hose to the tap as shown.
arrow and put(a) and (b) together.	b
	b

Notice :

•After completing connection, if water leaks from the hose, then repeat the same steps. Use the most conventional type of faucet for water supply. In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.

•The appliance is to be connected to the water mains using new hose-sets and that old hose-sets should not be used.

The end of the drain hose may be positioned in three ways:

Over the edge of a wash basin.

The drain hose must be placed at a height of between

60 and 90 cm. To keep the drain hose spout bent, use the supplied plastic hose guide. Secure the guide to the wall with a hook or to the faucet with a piece of string to prevent the drain hose from moving.

ln a sink drain pipe branch

The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60 cm above the ground.

ln a drain pipe

Samsung recommends that you use a 65 cm high vertical pipe; it must be no longer than 90 cm.

SAMSUNG Washing Machine Owner’s Instructions A-4