INSTALLING OF THE WATER DISPENSER LINE
For Exterior model
Connect to the water supply line
Connect the water pipe with coupler and tap.
-Close the main water tap.
-Connect coupler “A” to the tap.
-Every join should be protected with sealing tape.
WARRANTY INFORMATION
This water line installation is not covered by the
Follow these instructions carefully to minimise the risk of expensive water damage.
Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase the right couplers fittings.
CAUTION
The water line must be connected
to the cold water pipe.
If it is connected to the hot water pipe, it may cause the purifier to malfunction.
COUPLER “A”
TAP
Select the location where the purifier is to install. (Model with the purifier)
-Cut the water line attached to the purifier to the appropriate place after measuring the distance between the purifier and the cold water tap.
-If you wish to reassemble the water inlet and outlet sides of the purifier during purifier installation, see the reference illustration.
LINE OUTLET
SIDE OF | 90 degree | |
PURIFIER | ||
|
PURIFIERREFERENCE
WATER
WATER INLET | COUPLER |
| |
SIDE OF PURIFIER |
|
Remove any residual matter inside the purifier. (Model with the purifier)
-Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifier.
-If water does not come out through the line, check whether the tap is open.
-Leave the tap open until clean water is running out and any residual matter that built up during manufacturing has been removed.
OUTLET SIDE
OF PURIFIER
WATER
PURIFIER
WATER LINE
32