Monster Cable HTS5000 owner manual Troubleshooting

Page 31

TROUBLESHOOTING (continued)

Possible Cause #3

The PowerCenter’s power cord is plugged into an outlet on the back of one of your components and the component is not turned On.

Possible Solution

•Turn on the component.

NOTE: For the best possible performance, plug the PowerCenter into a wall outlet, not an outlet on another component.

Possible Cause #4

The PowerCenter is defective.

Possible Solution

• Please see page 35 for warranty information.

PROBLEM – PowerCenter is not providing power to the components.

Possible Cause #1

The component is plugged into an outlet programmed as “switched on” or “switched on after delay” and the PowerCenter has not been turned on.

Possible Solutions

•Press the ON button on the PowerCenter. The components plugged into the PowerCenter”s outlets programmed as ”switched on“ should be turned on immediately.

•Press the ON button on the PowerCenter and wait for a few seconds for the components plugged into the PowerCenter”s outlets programmed as ”switched on after delay“ to be turned on.

•Or, plug the component into an outlet programmed as “unswitched”.

25

Image 31

Contents HTS Table of Contents Important Safety Precautions Iii Page Important Note Proper Power and Protection Proper Grounding and Installation TipsThank You IntroductionMONSTER’S Patented Clean Power Stages Design Minds Behind the Monster Powercenter Page Before You Begin Content ChecklistDBS/DVD/Phone Line Hookup Hookup GuideOutlet Programming Outlet Programming SwitchesPage Remote AC Control Hookups Remote DC Control Hookups Dish in jack Coaxial Outlet HookupSatellite High Current Audio AC Outlet HookupAnalog Audio AC Outlet Hookup Video AC Outlet Hookup Digital AC Outlet Hookup OUT Rack Mounting Your PowerCenter Important Note HTS 5000 Features Index Drawings HTS 5000 FeaturesNumbers Refer to Drawings on Pages Delay Time Switch Selects delay time Easy reach to outlets Problem The PowerCenter is not receiving power TroubleshootingTroubleshooting Problem Speakers emit a humming or buzzing noise Problem The Switched on LED is off Problem The Unswitched on LED is offProblem Timed on LED is Off Possible Cause #2 What is the importance of component-to-component filtering? Frequently Asked QuestionsIf my PowerCenter stops operating, what do I do? Appendix a Glossary of Power-Related TermsPage Page Connected Equipment Warranty Warranty InformationAppendix B General Provisions As To Each WarrantyConnected Equipment Claim How To Make a ClaimPage Appendix C How to Contact UsRegister Your Product For Warranty Coverage Male Female Page Page Division of The Monster Group