Crimestopper Security Products CS-2004 WDC instruction

CS-2004 WDC

Remote Control Alarm System with CoolGlow & SecurWatch®

INSTALLATION & OPERATING INSTRUCTIONS

INTRODUCTION:

CONGRATULATIONS on your choice of a Remote Alarm System by Crimestopper Security Products Inc. This system features both a 4-Button CoolGlow Transmitter and a SecurWatch® Sports Watch Transmitter that feature anti code-grabbing technology. The remote code changes with every use of the transmitter making it impossible to scan or record the codes for use later on. This booklet contains the information necessary for installing, using, and maintaining the many features of this alarm system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the Tech Support number below.

*IMPORTANT INFORMATION: Primary and Optional Features

-PRIMARY:These are features that must be connected in order for the system to operate properly i.e. Siren, L.E.D., Power, Ground, Doorpin, etc.

-OPTIONAL:These are features to be connected only if desired or agreed upon by the installing dealer (i.e. Door Locks, Flashing Lights, Starter Kill, Hood, Trunk, and Auxiliary Remote Outputs etc.)

*NOTE: If the system is programmed for Carjack Protection, AUX 1 will not be available when using the SecurWatch® Remote Transmitter. AUX 1 can still be operated with the 4-Button CoolGlow transmitter when the system is setup for Carjack.

This device complies with FCC Rules part 15. Operation is subject to the following two conditions: 1) This device may not cause interference, and (2) this device must accept any interference that may be received, including interference that may cause undesired operation. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification to this equipment. Such modification could void the user's authority to operate the equipment.