Installation Instructions |
INSTALLATION
WARNING: FAILURE TO PROVIDE ADEQUATE STRUCTURAL STRENGTH FOR THIS MOUNT CAN RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s responsibility to make sure the structure to which this mount is attached can support five times the combined weight of the mount and all equipment attached to it. Reinforce the structure as required before installing the mount.
1.Determine location for mount keeping in mind display size, extension, height adjustment (if applicable), and pitch/roll requirements.
NOTE: Wall plate (D) MUST be installed into wood stud.
2.Using wall plate (D) as a template, mark then drill two 1/8" diameter pilot holes through top and bottom holes of wall bracket into wall structure. (See Figure 1)
3 | (F) x 2 | 2 |
|
Figure 1
3.Install two 3/8" x 3" hex head lag screws (F) through wall plate (D) and drywall into wood stud. (See Figure 1)
4.Ensure wall plate (D) is vertical, then tighten screws (D).
CAUTION: Overtightening screws may cause wall bracket to compress into soft wall surface, resulting in difficult mount installation or improper engaging of set screw in later step.
5.Insert top of wall mount (A, B or C) over lip on top of wall plate (D). (See Figure 2)
6.Swing wall mount down flush against wall.
(D) |
(A, B or C) |
5 |
6 |
Figure 2
7.Tighten set screw in bottom of wall mount. (See Figure 3)
NOTE: Ensure set screw engages on back side of wall plate to properly secure wall mount.
(A, B or C) |
| |
| (D) | |
7 | Set | |
Screw | ||
|
Figure 3
6