Installation Instructions |
|
| |
DISPLAY INSTALLATION |
|
|
|
1. Determine mounting pattern on display. |
|
|
|
WARNING: IMPROPER INSTALLATION CAN LEAD TO |
|
|
|
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL |
|
|
|
INJURY AND DAMAGE TO EQUIPMENT! DO NOT |
|
|
|
substitute hardware. Use only hardware supplied by |
|
|
|
manufacturer! |
|
|
|
WARNING: IMPROPER INSTALLATION CAN LEAD TO |
|
| 1 |
|
|
| |
ELECTRIC SHOCK OR DAMAGE TO EQUIPMENT! Screw |
|
|
|
length must not exceed the depth of threaded mounting insert |
|
|
|
in display. |
|
|
|
WARNING: OVERTIGHTENING OF SCREWS CAN |
|
| x2 |
DAMAGE PARTS AND LEAD TO SERIOUS PERSONAL |
|
| |
|
|
| |
INJURY AND DAMAGE TO EQUIPMENT! DO NOT over |
|
|
|
tighten screws when installing interface bracket. |
|
|
|
NOTE: If the display being installed has a 100x100 VESA |
|
|
|
mounting pattern, no interface bracket is required and |
|
| Figure 4 |
the display can be mounted directly to the mounting | 2. | Align two screws in display back with upper teardrop | |
plate as outlined below. | |||
NOTE: If the display being installed requires an interface |
| mounting holes in mounting plate and lower display until | |
| screws are seated in lower area of teardrop mounting holes. | ||
bracket, refer to the interface bracket installation |
| (See Figure 5) |
|
instructions. |
|
|
|
WARNING: IMPROPER INSTALLATION CAN LEAD TO |
| 2 | 2 |
DISPLAY FALLING CAUSING SERIOUS PERSONAL |
| ||
INJURY OR DAMAGE TO EQUIPMENT! Using screws of |
|
|
|
improper size may damage your display! Proper screws will |
|
|
|
easily and completely thread into display mounting holes. |
|
|
|
Ensure that screws are not too long. |
|
|
|
WARNING: IMPROPER INSTALLATION CAN LEAD TO |
|
| (A, B or C) |
DISPLAY FALLING CAUSING SERIOUS PERSONAL |
|
|
|
INJURY OR DAMAGE TO EQUIPMENT! Inadequate thread |
|
|
|
engagement in display may cause display to fall! Back out |
|
|
|
screws ONLY as necessary to allow installation of mounting |
|
|
|
plate! |
|
|
|
1. Start two M4 x 8mm Phillips pan head screws (included in |
|
|
|
hardware kit) into upper mounting holes in display back. |
|
|
|
(See Figure 4) |
|
|
|
NOTE: Leave at least 1/8" of each screw protruding out back |
|
|
|
of display. |
|
|
|
|
|
| Figure 5 |
| 3. | Install two more of the same screws through lower mounting | |
|
| holes in display mounting plate and into display back. | |
|
| (See Figure 6) |
|
7