Chauvet Vue III Before You Begin, What is included, Unpacking Instructions, AC Power, Contact Us

Page 3

1.BEFORE YOU BEGIN

What is included

¾1 x Vue™ III

¾Power Cord

¾Warranty Card

¾User Manual

Unpacking Instructions

Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture must be returned to the factory, it is important that the fixture be returned in the original factory box and packing.

AC Power

This fixture has an auto-switching power supply that can accommodate a wide range of input voltages. The only thing necessary to do before powering on the unit is to make sure the line voltage you are applying is within the range of accepted voltages. This fixture will accommodate between 100V and 240V AC. All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100% switch.

Contact Us

World Wide

General Information

Chauvet Lighting

 

3000 North 29th Court

 

Hollywood, FL 33020

 

voice:

954.929.1115

 

fax:

954.929.5560

 

toll free: 800.762.1084

Technical Support

Chauvet Lighting

 

3000 North 29th Court

 

Hollywood, FL 33020

 

voice:

954.929.1115 (Press 4)

 

fax:

954.929.5560 (Attention: Service)

World Wide Web

www.chauvetlighting.com

Vue™ III User Manual

3

2007-05-10/15:08

Image 3
Contents Outdoor OK 115V/230V SwitchUser Serviceable Ok on Dimmer2. INTRODUCTION TABLE OF CONTENTS3. SETUP 1. BEFORE YOU BEGINUnpacking Instructions What is includedAC Power 1.BEFORE YOU BEGINSafety Instructions Additional Features Features2.INTRODUCTION DMX Channel SummaryConnector Product OverviewTilt Adjustment Knob Dipswitches Sound Sensitivity Knob Microphone Power OutputData Cabling 3. SETUPFuse Replacement Fixture LinkingThe chart below details a proper cable conversion Setting up a DMX Serial Data LinkCABLE CONNECTORS 3-PINTO 5-PINCONVERSION CHARTRIGGING Stand-Alone/Master/SlaveFixture LinkingMounting ORIENTATIONDMX Mode 4.OPERATING INSTRUCTIONSOperation Master/Slave Mode Master Sound, Master AutoCluster DMX Channel ValuesControl/Operating Mode ClusterLED Cluster Values LED Cluster DiagramON OFF DMX Address Quick Reference Chart DMX QUICK REFERENCE CHARTApplies to General TroubleshootingDMX Primer General Maintenance5.APPENDIX Technical SupportWEIGHT & DIMENSIONS Returns ProcedureTechnical Specifications Claims