Chauvet Vue III user service Safety Instructions

Page 4
Safety Instructions

Safety Instructions

Please read these instructions carefully, which includes important information about the installation, usage and maintenance of this product.

Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet.

Always make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to is not higher than that stated on the decal or rear panel of the fixture.

This product is intended for indoor use only!

To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make sure there are no flammable materials close to the unit while operating.

The unit must be installed in a location with adequate ventilation, at least 50cm (20in) from adjacent surfaces. Be sure that no ventilation slots are blocked.

Always disconnect from power source before servicing or replacing lamp or fuse and be sure to replace with same lamp source.

Secure fixture to fastening device using a safety chain. Never carry the fixture solely by its head. Use its carrying handles.

Maximum ambient temperature (Ta) is 95°F (35°C). Do not operate fixture at temperatures higher than this.

In the event of a serious operating problem, stop using the unit immediately. Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest authorized technical assistance center. Always use the same type spare parts.

Don’t connect the device to a dimmer pack.

Make sure the power cord is never crimped or damaged.

Never disconnect the power cord by pulling or tugging on the cord.

Avoid direct eye exposure to the light source while it is on.

Caution!

There are no user serviceable parts inside the unit. Do not open the housing or

 

attempt any repairs yourself. In the unlikely event your unit may require service,

 

please contact CHAUVET at: 954-929-1115.

Vue™ III User Manual

4

2007-05-10/15:08

Image 4
Contents 115V/230V Switch User ServiceableOk on Dimmer Outdoor OKTABLE OF CONTENTS 3. SETUP1. BEFORE YOU BEGIN 2. INTRODUCTIONWhat is included AC Power1.BEFORE YOU BEGIN Unpacking InstructionsSafety Instructions Features 2.INTRODUCTIONDMX Channel Summary Additional FeaturesProduct Overview Tilt Adjustment Knob Dipswitches SoundSensitivity Knob Microphone Power Output Connector3. SETUP Fuse ReplacementFixture Linking Data CablingSetting up a DMX Serial Data Link CABLE CONNECTORS3-PINTO 5-PINCONVERSION CHART The chart below details a proper cable conversionStand-Alone/Master/SlaveFixture Linking MountingORIENTATION RIGGING4.OPERATING INSTRUCTIONS OperationMaster/Slave Mode Master Sound, Master Auto DMX ModeDMX Channel Values Control/Operating ModeCluster ClusterLED Cluster Diagram LED Cluster ValuesON OFF DMX QUICK REFERENCE CHART DMX Address Quick Reference ChartGeneral Troubleshooting Applies toGeneral Maintenance 5.APPENDIXTechnical Support DMX PrimerReturns Procedure Technical SpecificationsClaims WEIGHT & DIMENSIONS