Assembly and Installation

Installation Instructions

PTS SERIES

WARNING: FAILURE TO PROVIDE ADEQUATE STRUCTURAL STRENGTH FOR THIS COMPONENT CAN RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component.

Attaching Post Assembly to Base Assembly

1. Using four 5/16-18 x 5/8" button head cap screws (F) and four 5/16-18 Nylock nuts (G), secure post assembly (B) to base assembly (D). (See Figure 1)

(B)

(F) x 4

(D)

(G) x 4

Figure 1

2.Attach edge trim pieces (C) to the base assembly (D). See Figure 2.

2 (C) x 2

Figure 2

Attaching Faceplate Assembly

1.Align mounting holes in faceplate assembly (A) with holes in post assembly (B). (See Figure 3)

NOTE: The faceplate assembly can be placed within a four inch range on the post assembly, dependent on size of display.

2.Attach faceplate assembly to post assembly using four 5/16-18 x 5/8" button head cap screws (F). (See Figure 3)

(A)
2	(F) x 4
(B)

Figure 3

Attaching Interface Bracket to Display

1.Attach interface bracket to display following instructions included with interface bracket kit.

Attaching Display to Mount

1.While supporting both sides of display, align four mounting buttons on display or interface bracket with four mounting holes in mount. (See Figures 4 and 5)

Figure 4