Adjustment Nut

Installation Instructions

PTS SERIES

NOTE: Roll tension is preset. If the display does not remain in the desired position, perform the following roll tension adjustment procedure.

1.Remove display following the Removing Display section.

2.Remove four 5/16-18 x 5/8" button head cap screws from back of post assembly (inserted in Step 2 of Attaching Faceplate Assembly section).

3.Locate roll tension adjustment nut on back of faceplate. (See Figure 8)

Roll Tension

Figure 8

4.Partially loosen or tighten the roll tension adjustment nut as needed.

5.Re-install the faceplate assembly onto the post assembly following instructions in Attaching Faceplate Assembly section.

6.Re-mount the display following instructions in Attaching Display to Mount section.