Removing Display

PTS SERIES

Installation Instructions

WARNING: DISPLAY MAY WEIGH IN EXCESS OF 40 LBS! Always use two people and proper lifting techniques when installing or positioning display on mount.

2.Lower display into place listening for audible "click" to ensure recessed area of mounting buttons are properly seated in lower area of mounting holes. (See Fig. 4 and 5)

WARNING: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Ensure mounting buttons are completely engaged in mounting holes.

NOTE: Holes are provided in the faceplate for use with a padlock or similar locking device, if desired. In addition, the pin and nut may be removed from the upper holes and moved to the lower holes for use as a more permanent locking device. (See Figure 5).

2	Remove bolt
	or padlock	3
	if used
Pin in
"Closed"
position -
move to
"Open"
position to
remove
display
	5

May remove pin and nut and move to lower holes

A padlock or bolt may be placed through latch holes

Pin in

"Open"

position -

move to

"Closed"

position

after display

is removed.

Figure 6

Figure 5

1.Disconnect all power/audio/video cables.

2.Remove bolt or padlock from faceplate (if used). (See Figure 6)

NOTE: The pin may have been used as a more permanent locking device. If so, remove nut and pin and move from the lower holes to the upper holes.

3.Pull back on flag on upper mounting hole and press pin down into "Open" position. (See Figure 6)

WARNING: THE DISPLAY MAY WEIGH IN EXCESS OF 40 LBS EACH! Always use two people and proper lifting techniques when installing or positioning display.

4.Carefully lift display from mount.

5.Lift up on pin and place flag back against faceplate to return it to "Closed" position. (See Figure 6)

Adjusting Roll Tension

The faceplate provides 2o roll adjustment. (See Figure 7) Roll adjustment is accomplished by shifting the faceplate right or left as needed until the faceplate is level.

Figure 7