Chief Manufacturing MIWRF Series Extend/Retract Tension Adjustment, Display Height Adjustment

Installation Instructions MIWRF SERIES

2

1

3

Figure 15

Extend/Retract Tension Adjustment

Arm Extend and Retract tension is pre-set at the factory and is adjusted to accommodate displays with weights near the top of the mounts capacity.

If smaller displays are used it may be difficult to reposition the display after mounting. Arm Extend and Retract tension can be adjusted to compensate for smaller display by:

The display must be mounted prior to adjusting swing arm tension.

1.With display installed, tighten or loosen adjustment screw using hex wrench. (See Figure 16)

2.Check for desired tension.

3.Repeat Steps 1 and 2 until desired tension is obtained. NOTE: If changing from a smaller display to a larger display

may be necessary to increase tension.

1

(on back side

in this view)

2

Figure 16

Display Height Adjustment

The mount is designed to accommodate up to 1" of display height adjustment.

To adjust display height:

1.With display installed, loosen adjustment locking screw using hex wrench. (See Figure 17)

2.Adjust display height by turning adjustment nut in desired direction. (See Figure 17)

3.Tighten adjustment locking screw when display is at desired height. (See Figure 17)

1

3

2

Figure 17

9