3. Setup
AC POWER
Warning! | Verify that the power requirement label on your unit matches the line voltage |
| applied. All fixtures must be connected to circuits with a suitable Earth Ground. |
| To determine the power requirements for a particular fixture, see the label affixed to the back plate |
| of the fixture or refer to the fixture’s specifications chart. |
| A fixture’s listed current rating is its average current draw under normal conditions. |
| All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat |
| (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% |
| to 100% switch. |
| Before applying power to a fixture, check that the source voltage matches the fixture’s |
| requirement. |
| All fixtures must be connected to circuits with a suitable Earth Ground. |
Pow er Cable Config ura tion
CABLE | Pin | International | Screw Color |
|
|
|
|
BROWN | Live | L | Yellow or Brass |
|
|
|
|
BLUE | Neutral | N | Silver |
|
|
|
|
YELLOW/GREEN | Earth | EG (Ground) | Green |
|
|
|
|
MOUNTING
Orie ntati on
This fixture can be mounted on a truss using a clamp in any position or against a flat surface using the brackets provided.
Rigging
The fixture includes a mounting yoke to which 1 rigging clamp can be bolted | Hanging Clamp | |
and (2) Flush Mount Brackets for flush mounting to flat surfaces. You must |
| |
supply your own clamp and make sure the clamp is capable of supporting the |
| |
weight of this fixture. You can order |
| |
distributor. |
|
|
1. | Block access below the work area and use suitable and stable |
|
| platform when installing or servicing fixture. |
|
2. | Align the clamp screw with the center hole on the yoke and |
|
| tighten. |
|
Flush Mounting Bracket
3.Verify the structure can hold 10 times the weight of all
4.Adjust the angle on the yoke arm as necessary.
5.Always use a safety cable or chain as a secondary source of attachment. The safety cable must hold 10 times the weight of the fixture. If safety cable attachment point is provided that is permanently affixed to the surface or body of the fixture, use that instead of looping through a hanging yoke/arm.
Flush Mounting
1.Draw a screw hole template on a large piece of vellum or transparent paper for best alignment.
2.Place paper against the mounting surface and drill holes or mark the surface for drilling.
3.Hang Panel.
7 |