timer display will begin to blink. While it is blinking, press the timer button again. The
time will disappear from the Timer Display and an “F” will be displayed. The timer has
now been cancelled.
2) Remote Control
ON/ OFF | FAN SPEED |
TEMP/ TI ME
TI MER | MODE |
The six buttons on the remote control are same as the six buttons on the control panel of the main unit. See the control panel section above for an explanation of how to use the buttons.
The remote control uses a lithium battery model CR2025. The battery must be installed prior to using the remote control.
3) Modes
Dehumidifying
1)Plug the power cord into a power outlet.
2)Turn on the unit.
3)Press the Mode button until the LED next to “Dry” lights up.
During the Dehumidifying mode, the unit will condense water out of the air and exhaust it through the exhaust hose. The ambient temperature in the room will probably drop by a few degrees while using the Dehumidifying mode.
Notes:
The fan always runs on low speed while in the Dehumidifying mode.
If you do not use the exhaust hose in Dehumidifying mode, you must manually drain the water from the unit. Additionally, the ambient temperature in the room will
12