To Replace Filter Dust Bag, General Information

1	2	Upper
		Handle

Connector

Assembly

Plug (Cord Assembly)

Cord dump

11	12
	ENFONCEZ JUSQU’À
	TENDRENBRUN	IT
	PRESIONEHASTA
		ESUCHARUN
	CHASQUIDODESUJECI	ÓN

fig. 1 Before assembling appliance, remove two screws from the connector assembly. Remove cardboard

insert by pulling upward.

fig. 2 With ON/OFF switch facing the front of the unit, slide upper handle section over matching section

of the connector assembly. Insert short screw into top hole and long screw into the bottom hole then tighten firmly until handle is no longer loose.

fig. 3 Attach cord to cord clip by pressing cord above and below clip ensuring the cord is fully rested in

clip.

fig. 4 Insert plug on cord assembly into handle.

NOTE: Do not operate the unit while in the upright and locked position. Do not let the unit run while in any one stationary position for any period of time. Keep the unit moving while in operation.

For Easy Power Cord Storage

fig. 6 Wrap power cord around cord dump on Helping Hand® handle and cord hook on connector. Secure to "U" shaped part on plug

fig. 7 To release cord, twist cord dump located on Helping Hand® handle 1/2 turn. Slide cord off

handle.

To Replace Filter

Dust Bag

WARNING: Unplug cord from electrical outlet before servicing.

fig. 8 Unzip outer bag completely.

fig. 9 Pull bag cardboard collar to release bag dock door from connector. Bag dock door will hinge downward.

fig. 10 Gently pull bag cardboard collar upward out of the bag dock. Dust seal will close automatically.

General Information

Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet and press the On (l) - OFF(O) switch on Helping Handle Assembly when ready to operate.

Up-Position Lock

fig. 5 Place foot on power head and lean handle back gently to release lock for vacuum use. Return

handle to the full upright position to engage lock.

Bag Installation

fig. 11 Slide the cardboard collar completely onto bag dock door.

fig. 12 Firmly push bag dock door with both thumbs on indication point until it snaps.