Oreck XL2300RS, XL2200RS, XL2250RS warranty Assembly Operating Instructions, To Operate

Page 4

E N G L I S H

Assembly

Operating Instructions

To assist you in identifying components of your vacuum, the parts have been numbered as follows:

1Handle section, upper

2Tube, lower

3Power head

4Outer bag

5Paper filter dust bag 5

6Power cord

7Retaining spring

8Bag tension bar

9Zip fastener

10On/off switch

11Cord hook

12Connector assembly

13Fan housing

9 1

11

4 12

2

6

10 7 13

8

3

To Operate

Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet and press the On (l) - OFF (O) switch on top of base when ready to operate.

General Information

The performance of your new cleaner greatly depends upon care and maintenance. The instructions in this manual will guide you in performing basic care and maintenance. To obtain the most satisfying years of service read the instructions and keep them handy for future reference.

Operating Recommendations

This new ORECK XL High-Speed Upright is one of the finest, fastest, and strongest units in its class. You’ll love the way it cleans, gets under things, and it’s SO lightweight and easy to use.

The following are a few simple suggestions regarding its operation:

Upper

Handle ➞

➞

Connector

Assembly

Before assembling appliance. Remove two (2) screws from connector assembly (12). Slide upper handle section (1) over matching section of the connector assembly (12), aligning screw holes. Finally, insert screws in holes and tighten firmly until handle is no longer loose.

1.When inserting a new disposable paper filter dust bag— FIRST PUFF OUT and OPEN THE BAG.

2.When the disposable filter dust bag is full, REPLACE IT.

3.If at any time the machine does not pick up properly or makes an unusual noise, STOP OPERATION and service.

4.Although your upright will pick up pins, paper clips, and other small objects, it is recommended that these be removed from the floor before you vacuum. Failure to do so may result in permanent damage to the motor suction fan and its housing.

5.WARNING: Do not use your vacuum cleaner on damp or wet surfaces. This will cause damage to the vacuum cleaner and is dangerous to the user. Damage caused by use on wet or damp surfaces is not covered under warranty.

6.REPLACE THE BELT EVERY 6 MONTHS.

7.Change the disposable filter dust bag at least once a month—even if it is not full! The collected dust in the dust

bag can cause odor, attract moisture, act as a breeding area andruncantheaffectvacuumthe efficiecleanercy overf thecordcleaner. The.

8.rDOevolNOTving brush could damage the cord.

Disposable Paper Filter Dust Bags

Disposable paper filter dust bags play a very important role in the efficiency of your ORECK vacuum cleaner. The purpose of the paper bag is to trap dirt, but at the same time it must be porous enough to allow air to pass through. If the paper bag becomes clogged, no air can pass through the cleaner and cleaning cannot take place, regardless of the cleaner’s power. Increase the CLEANING POWER of your cleaner by changing the bag often.

To keep your cleaner operating at maximum efficiency, change the dust bag frequently. DO NOT FILL ABOVE THE LINE INDICATED ON THE DUST BAG.

Be sure the disposable paper filter dust bag is installed properly.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents XL2250RS XL2200RS XL2300RS Maintenance Customer Service Table of ContentsAccessories Sold Separately Troubleshooting Guide WarrantySave Service CALLS...CHECK These First Assembly Operating Instructions To OperateTo Replace Filter Dust Bag BeltHow to Replace a Worn Belt Stuffing or BlockageUsing a Fresh Air Tab To Adjust or Replace BrushBulb Replacement Accessoires Vendu Séparément Entretien et service La clientèleTable des matières Garantie Avis de fiche polariséeGuide de dépannage AssemblageMode d’emploi Remplacement du sac à poussières filtrant Remplacement d’une Courroie uséeBlocage ou bourrage Remplacement de l’ampoule électriqueUtilisation d’une Tablette Fresh AirMC Réglage ou remplacement Du balai ¡GUARDE Este FolletoIndice Mantenimiento y servicio ClientesAccesorios Vendido por separado Aviso de la clavija polarizadaGuía para identificación De problemas GarantíaEnsamblaje Para reemplazar la Bolsa para polvo de filtroInstrucciones de operación Cómo reemplazar una Correa desgastada Para ajustar o reemplazar El cepilloUso de una tableta Fresh Air Relleno o bloqueoReemplazo de la bombilla

XL2250RS, XL2300RS, XL2200RS specifications

The Oreck brand is synonymous with lightweight and efficient vacuum cleaners, and their models XL2300RS, XL2250RS, and XL2200RS exemplify these qualities. These models are built with advanced features designed to ensure effective cleaning while maintaining easy maneuverability.

The Oreck XL2300RS is engineered with a powerful 8-pound design that makes it easier for users to lift and navigate throughout the home. One of its standout features is the SaniSeal Technology, which automatically seals the vacuum bag when it is removed, preventing dust and allergens from escaping back into the air. This model is also equipped with a 102-mile per hour airflow, optimizing its suction power to pick up both large debris and fine dust particles effectively. The XL2300RS includes a durable, hypoallergenic inner bag that captures 99% of particles down to 0.3 microns, making it ideal for allergy sufferers.

Moving on to the Oreck XL2250RS, this vacuum showcases a similar lightweight design, ensuring easy movement even in tight spaces. A unique characteristic of this model is its ability to lay flat, allowing users to clean under furniture and obstacles effortlessly. Additionally, it comes with a side edge cleaning technology that enhances the cleaning power along baseboards and furniture edges. Like the XL2300RS, the XL2250RS also features the hypoallergenic inner bag, ensuring a cleaner home environment.

Lastly, the Oreck XL2200RS continues the tradition of lightweight functionality in the Oreck family. Known for its simplicity and reliability, the XL2200RS includes a 6 amp motor that delivers strong suction to ensure effective cleaning on both carpets and hard surfaces. The model is designed with a High-Speed Roller Brush, which rotates at an impressive 6,500 revolutions per minute (RPM), allowing for maximum dirt pickup. Additionally, this vacuum is designed to reduce strain on the wrist with its ergonomic handle, enabling users to clean for longer periods without discomfort.

In summary, the Oreck XL2300RS, XL2250RS, and XL2200RS models feature lightweight designs, strong suction capabilities, and technologies aimed at maximizing user convenience and cleaning effectiveness. Their hypoallergenic bags and edge-cleaning functionalities make these vacuums ideal choices for those seeking a powerful yet easy-to-use cleaning solution for their homes.
Top Page Image Contents