Oreck DTX 1100 warranty Warranty, Troubleshooting Guide

Page 3

E N G L I S H

Warranty

ORECK MANUFACTURING COMPANY: (ORECK gives you the following limited warranty for this product only if it was originally purchased for use, not resale, from ORECK or an ORECK Authorized Retail Dealer.)

ORECK will repair or replace, free of charge, to the original purchaser, any part which is found to be defective in material or workmanship within three (3) years of the date of purchase; five (5) years on motor. Any commercial use of this product will void this limited warranty.

Drive belts, revolving brushes, disposable bags, and other parts subject to normal wear are not covered by this limited warranty.

This limited warranty does not apply to any part subjected to accident, abuse, commercial use, alteration, misuse, damage caused by fire or act of God, the use of voltages other than indicated on the serial number plate of this product or service of this product by other than ORECK or an ORECK Factory Authorized Service Center.

ORECK does not authorize any person or representative to assume or grant any other warranty obligation with the sale of this product.

ORECK’s limited warranty is valid only if you retain proof of purchase from ORECK or an ORECK Authorized Retail Dealer for this product. If you purchase this product from any other source, your purchase is “AS IS,” which means ORECK grants you no warranty, and that you, not ORECK, assume the entire risk of the quality and performance of this product, including the entire cost of any necessary servicing or repairs of any defects.

ORECK’s liability for damages to you for any costs whatsoever arising out of this statement of limited warranty shall be limited to the amount paid for this product at the time of original purchase, and ORECK shall not be liable for any direct, indirect, conse- quential or incidental damages arising out of the use or inability to use this product.

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

ALL EXPRESSED AND IMPLIED WARRANTIES FOR THIS PRODUCT, INCLUDING IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD, AND NO WARRANTIES, WHETHER EXPRESSED OR IMPLIED, WILL APPLY AFTER THIS PERIOD.

Some states do not allow limitations on the duration of implied warranties, so the above limitation may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Troubleshooting Guide

WARNING: Unplug cord from electrical outlet before servicing.

SAVE SERVICE CALLS...CHECK THESE FIRST:

Is the disposable filter dust bag full?

Are pores of filter dust bag clogged with powder or fine dust?

Is anything clogging the hose, wands, power nozzle & accessories?

 

PROBLEM

POSSIBLE SOURCE

AREAS TO CHECK

 

CLEANER

Not plugged in

Be sure cleaner is

 

WILL NOT RUN

properly.

firmly plugged

 

 

 

into wall outlet.

 

 

No electricity in

Check electrical

 

 

wall outlet.

source–fuse or

 

 

 

circuit breaker.

 

 

 

 

 

CLEANER

Filter bag is full.

Replace filter bag.

 

DOES NOT PICK UP

 

See “To Install

 

 

 

Filter Bag.”

 

 

Intake & Exhaust

Replace Filters.

 

 

Filters are blocked.

See “Replacing

 

 

 

Intake Filter”, &

 

 

 

“Replacing

 

 

 

Exhaust Filter”.

 

 

Hose, Wand or

Clear obstruction.

 

 

Accessories are

 

 

 

clogged.

 

 

 

Suction Control on

Close Suction

 

 

Handle is open.

Control.

 

 

 

 

 

POWER NOZZLE

Handle Switch is

Turn Handle

 

WILL NOT RUN

Off.

Switch On.

 

 

Brush in Power

Remove clog, wait

 

 

Nozzle is

ten minutes for

 

 

clogged.

Power Nozzle to

 

 

 

reset.

 

 

 

 

ALL OTHER SERVICING SHOULD BE DONE BY AN ORECK AUTHORIZED SERVICE CENTER.

CALL CUSTOMER SERVICE HOT LINE

US: 1-800-989-3535

CANADA: 1-888-676-7325

Whenever calling, please be sure to have your model and serial number from data plate.

3

Image 3
Contents DTX Table of Contents Maintenance Customer ServiceAccessories Sold Separately Troubleshooting Guide WarrantyDusting Brush Crevice Tool AssemblyGetting Ready for Use Cordwinder Pedal Exhaust Filter Upholstery ToolPull plug from unit and insert into wall outlet Insert power nozzle plug into the plug holder on upper wandInsert power handle into upper wand until button locks Operating InstructionsReplacing Filter Bag Replacing Motor FilterReplacing Exhaust Filter Remove exhaust grill StorageEntretien et service La clientèle Accessoires Vendu SéparémentTable des matières Guide de dépannage GarantiePréparation AssemblageBouton se verrouille Mode d’emploiUtilisez la languette située en haut de la grille du filtre Replacez le porteur dans lunitéRangement Installation DU Filtre Hepa AvancéFiltro avanzado Hepa IndiceMantenimiento y servicio Clientes Accesorios Vendido Por separadoGarantía Guía para identificación De problemasEnsamblaje17 Preparación para su utilizaciónMango estándar con manguera Botón calce Preparación para su utilización Instrucciones de operaciónVolver a colocar la caja dentro de la unidad Reemplazo del filtro del escapeDentro de las ranuras y AlmacenamientoExtraer la rejilla de escape Calzar cerrado07/02 ECN# R-6614