EdgeStar AP10000HW owner manual Maintenance Water Drainage, Repeat until the unit is emptied

Maintenance – Water Drainage

This portable air conditioner is designed to exhaust most or all water dehumidified from the air. In high humidity situations, the internal water reservoir may fill. If the reservoir is full, both the compressor and motor will stop and the unit will buzz a warning (you can press any button to stop the buzzing). The “Water” indicator will flash to show you that the reservoir is full. The unit will not operate until you drain the water.

Please empty the water in one of the following ways:

1.Turn off the air conditioner (avoid moving it when full).

2.Position a container (a water tray, for example) underneath the drain hole.

3.Remove the drain cap & rubber plug from the drain hole and allow the water to drain out.

4.When the container is almost full, replace the rubber plug in the drain hole and empty the water tray.

5.Repeat until the unit is emptied.

6.Replace the rubber plug and tighten the drain cap firmly.

7.Switch on the unit – the Water Full indicator will stop flashing.

Drain hole

FIG.15

Rubber plug

Drain cap

If you wish to operate the unit without the need to empty the water tank, please:

•Remove the drain cap and rubber plug and retain for future use.

•Connect the drain tube supplied to the

water outlet as shown and locate the other end into a drain. (see the next

page for more information) Rubber plug

Drain cap

FIG.16

13