Heath Zenith SL-4100 warranty Securing Brass and Plastic Post Lamps, Troubleshooting Guide

MINUTES 20

5

1

TEST

ACCENT

DUSK TO DAWN 6 HOUR 3 HOUR

OFF

ON-TIME

1. Walk through the coverage area noting where you are when the lights turn on. Loosen the 3 clamp screws slightly and turn the sensor head left or right to change the coverage area.

2. When you have the desired coverage angle make a pencil mark on the sensor and post to mark the sensor position.

3. If you need to change the sensitivity, tem- porarily lift the fixture and sensor to make the adjustment. It may be necessary to have a friend hold the fixture while adjust- ing the sensitivity.Too much sensitivity may increase false triggering.

4. Set the amount of TIME you want the light to stay on

after motion is detected. (1, 5, or 20 minutes).

5. Set the DualBrite® (ACCENT) switch to the amount of time after dusk you want the lights on at low level (Off, 3, 6 Hrs., Dusk-to- Dawn).

6Put the sensor and fixture back in place. Align the pencil marks made above. Tighten the three screws to secure the sensor.

Securing Brass and Plastic Post Lamps

WARNING: Turn power off at circuit breaker or fuse.

1.Turn the post lamp to the desired loca- tion. Using a #31 drill and the fixture as a template slightly mark the location of one of the fixture mounting holes.DO NOT drill through the sensor plastic.

2.Lift the fixture off the sensor and keep the wires away from where you need to drill. Now finish drilling the first hole.

3.Set the fixture in position and install a screw (provided) to hold the fixture.

4.Mark the remaining holes as above.

5.Remove the one screw and lift the fixture and drill the remaining holes as above.

6.Set the fixture in position and install all the screws (3 provided). Be careful to not over tighten the screws and strip out the plastic.

TROUBLESHOOTING GUIDE

SYMPTOM	POSSIBLE CAUSE
Light will not	1. Light switch is turned off.
come on.	2. Bulb is loose or burned out.
	3.	Fuse is blown or circuit breaker is turned
		off.
	4.	Daylight turnoff is in effect (Recheck
		after dark).
	5.	Incorrect circuit wiring, if this is a new
		installation.
	6.	Re-aim the sensor to cover desired
		area.
Light comes	1. Light control may be installed in a
on in daylight.		relatively dark location.
	2.	Light control is in Test. (Set control
		switch to an ON-TIME position).
Light comes	1. Light control may be sensing small
on for no ap-		animals or automobile traffic (Re-aim
parent reason.		sensor).
	2.	Sensitivity is set too high. (Reduce
		sensitivity).

SYMPTOM	POSSIBLE CAUSE
Light stays on	1. The sensor is pointed at nearby
continuously.		objects that cause heat to trigger
		the sensor. (Aim the sensor away
		from nearby objects).
	2.	Light control is in Manual Mode.
		(Switch to Auto.)
	3.	Light control is in DualBrite®
		mode.
	4.	Sensitivity is set too high. (Reduce
		sensitivity.)
Light flashes on	1. Heat being reflected from other
and off.		objects may be affecting the sensor.
		(Re-aim sensor).
	2.	Light control is in the Test mode and
		warming up. (Flashing is normal
		under these conditions).

595-5657-04