Remove any residual matter inside the purifier. (Model with the coolselect zone)
1.Turn ON the main water supply.
2.Run water through the dispenser until the water runs clear (approximate 3 liter).
The initial dark discoloration of water and ice is normal
INSTALLING THE WATER DISPENSER LINE
For Exterior model
Parts for water line Installation
Pipe connector Water line fi xer and screws
Water line | Purifi er | Purifi er |
Connecting to the water supply line
Connect the water pipe with coupler and tap.
1.Close the main water tap.
2.Connect coupler “A” to the tap.
CAUTION
The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifi er to malfunction.
WARRANTY INFORMATION
This water line installation is not covered by the refrigerator or ice maker manufacturer’s warranty. Follow these instructions carefully to minimise the risk of expensive water damage.
Note:
If the coupler does not fi t on the current tap, go
the nearest authorized service dealer and purchase the right couplers fi ttings.
select the location where the purifier is to install. (Model with the purifier)
-If you wish to reassemble the water inlet and outlet sides of the purifi er during purifi er installation, see the reference illustration.
-Cut the water line attached to the purifi er to the appropriate place after measuring the distance between the purifi er and the cold water tap.
COUPLER “A”
|
| TAP | |
| LINE OUTLET | ||
SIDE OF |
| 90 degree | |
PURIFIER |
| CAUTION | |
|
| ||
PURIFIER WATER | Insert Locking Clip After | ||
tube seated | |||
|
| ||
WATER INLET | COUPLER | ||
SIDE OF PURIFIER |
| Locking Clip | |
|
|
English - 22
2013. 12. 26. 7:18 |