Dayton 3VH19 manual Maintenance, To Restart Heater, To Stop Heater

Dayton Operating Instructions and Parts Manual

Model 3VH19

Operation (Continued)	TO RESTART HEATER
8. When pilot remains lit, start heater by	1.	Wait five minutes after stopping
		heater.
slowly turning control valve knob 1/4
turn to left to ON position (see Figure 5).	2.	Restart heater by following steps under
PILOT		To Start Heater.

3VH19

ON ONOFF “PILOT”FROMPOSITION PUSHSLIGHTTO TURNOFF PUSHFULLTO LIGHT OFF

Figure 5 - ON Position

Piezo

Ignitor

Button

Control Valve Knob

Figure 6 - Control Valve Knob and Piezo Ignitor Button Locations

STORAGE

Disconnect heater from natural gas

supply.

1.Place plastic cover cap over brass fitting on inlet connector.

2.Store in dry, clean, and safe place.

3.When taking heater out of storage, always check inside of heater. Insects and small animals may place foreign objects in heater. Keep inside of heater free from combustible and foreign objects.

Maintenance

Never attempt to service heater

while it is connected to propane supply, operating, or hot. Severe burns can occur.

TO STOP HEATER

1.Close valve on gas supply.

2.Turn control valve knob 1/4 turn to right to PILOT position. Slightly push in knob and turn 1/4 turn to right to OFF position (see Figure 7).

PILOT

	LIGHT	FULL PUSHTO	SLIGHT PUSHTO TURN OFF	FROM “PILOT”POSITION	ON OFF
ON						OFF

Figure 7 - OFF Position

1.Keep heater clean. Clean heater annually or as needed to remove dust and debris. If heater is dirty or dusty, clean heater with a damp cloth.

2.Inspect heater before each use. Check connections for leaks. Apply mixture of liquid soap and water to connections.

Bubbles forming show a leak. Correct all leaks at once.

3.Have heater inspected yearly by a qualified service agency.

4.Keep inside of heater free from combustible and foreign objects.

®

5

Version B - For Reduction G016.J