Campbell Hausfeld WT4500, WT5500 warranty Maintenance, Torch Use

Propane Torch Kit

Juego de soplete de propano

Notes

Notas

www.chpower.com

Models WT4500 and WT5500

			4. For the WT4500, use flint striker to
			ignite torch by creating a spark near
			torch nozzle (see Figure 6a). For the
			WT5500, press the piezo ignitor
			switch near handle (see Figure 6b).
				Do not use matches
			! WARNING
				or cigarette lighter
			to ignite torch.
Figure 3 - Hand tightening cylinder					Figure 7 - Pulling trigger for flame
connection					turbo blast (WT4500 shown, WT5500
					similar)
					are equipped with an excess-flow check
					valve that shuts off the gas in the event
					of a damaged or severed hose. If you
					allow the flame to grow too large, the
					excess-flow check valve will automatically
			Figure 6a - Using flint lighter		shut off gas flow to the torch.)
					To extinguish the flame, close the
					torch gas flow valve and propane
					cylinder valve. Make certain that
					torch is completely cooled before
					storing. The torch nozzle will be very
Figure 4 - Tightening cylinder connection
with wrench					hot. Do not touch it or rest it on
					anything that can be damaged by heat.
					Maintenance
					Prior to each use:
					1. Inspect all components of the device
			Figure 6b - Using piezo ignitor
					for damage and or wear.
						If the hose shows
			5. Adjust flame to a minimal level with		! WARNING
						excessive abrasion
			torch gas valve.		or wear, if the hose is cut, or if it is
					more than 5 years old, it must be
			Torch Use		replaced prior to operation.
					2. Inspect LP gas tank for dents,
Figure 5 - Turning gas valve (clockwise
to close, counterclockwise to open)			Point torch at what you want to heat		damage to collar, damage to shut-off
(WT4500 shown, WT5500 similar)			and pull Turbo Blast Trigger to intensify		valve or corroded foot ring.
Lighting Instructions			the size of the flame (see Figure 7).			If dents, damage to
					! WARNING
			Release trigger to bring flame back to			collar, damage to
(Cont.)
			minimal level.		shut-off valve or corroded foot ring are
		DO NOT smoke	NOTE: If you have the torch gas valve		present, the LP gas tank must be
	! WARNING				replaced prior to operation.
		around or expose
supply tank to open flames or sparks.			open too high, when you pull the		3. Perform a leak test using soapy water
			Turbo Blast Trigger, the flame will tend
		DO NOT apply heat			or leak test solution.
	! WARNING		to “blow out” and require reignition.
		or flame to tank to			4. Ignite the torch according to lighting
check for leaks. Excess heat may cause			On the WT5500, there is an adjustable
					instructions. Check operation of
the tank to rupture, possibly causing			brass knob used to limit the distance
					adjusting valve and all other
personal injury.			the Turbo Blast Trigger can move. Turn
					components prior to proceeding.
3. Slowly open valve on torch about 1/8			the valve clockwise for a smaller flame.
					Periodically:
	turn until you hear gas flow.		Turn it counterclockwise for a larger
			flame. (As a safety precaution, these units		1. Remove any debris or combustible
						www.chpower.com

10 3