Models WT4500 and WT5500

Modelos WT4500 y WT5500

www.chpower.com
11
Notes
Notas
2
Propane Torch Kit
www.chpower.com
Safety Information
(Cont.)
• This product is intended for outdoor
use only.
•This product produces a
flame that can cause
other combustible and
flammable materials to
burn.For example, if using the flame
to soften paint on wood, you can
damage or even ignite the wood.
• Do not use the torch around
any flammable fluids,
gasses, or materials.
• NEVER direct the torch flame toward
the hose or gas tank. DO NOT apply
heat or flame to the tank to check
for leaks or increase gas pressure.
• Always wear ANSI-approved
safety goggles when
assembling and using this
product. Long sleeves,
gloves, and boots are recommended.
• If you are using this product and
notice a gas odor, immediatelyshut
off the tank valve. Extinguish any
open flame. Check the device for
leaks using soapy water. DO NOT
attempt to reignite the device until
all leaks are repaired and there is no
gas smell.
• Do not operate this product if under
the influence of alcohol or drugs.
• IN DAYLIGHT, THE TORCH FLAME IS
BARELY VISIBLE. DO NOT place hand
or any other body part in the path of
the flame while lighting or operating
the torch.
• Before use, determine whether any
materials that will be heated by the
torch will ignite, explode, or produce
toxic fumes. DO NOT allow flame or
heat to come into contact with any
such materials.
• Never point the torch toward any
person or animal.
• Never allow children to use the
propane torch. Keep children and
pets away from this product when in
use.
• Do not leave the torch unattended
while in operation.
• Do not stand or prop the torch on
the burner end while in operation.
• Do not try to enlarge or make any
modifications to the nozzle outlet.
The nozzle and orifice are precisely
matched. Any modification can
create the possibility of liquid
propane release.
• This product is designed to be
operated on vapor withdrawal LP
(liquid propane) gas only. Use of any
other gas may result in device failure
or personal injury.
• This product should be used with 20#
propane cylinders with standard POL
valve fittings. It should meet or
exceed NFPA 58, “Standard for the
storage and handling of liquefied
petroleum gasses.”
• Before each use, always check
fittings and connections to make
sure there are no leaks.
• When not in use, the gas should be
turned off at the LP gas tank.
• The LP tank must be on a level
surface in an upright position. Do
not invert or lay tank on its side.
• Have an ABC type fire extinguisher
readily accessible at the work site.
• Before each use, check the gas hose
for wear, cuts, or leaks. If the hose is
more than 5 years old (as marked on
the hose), replace it.
• Do not attempt to repair. Contact
Campbell Hausfeld for replacement
under warranty.
Never store a torch
that is still hot.
Be aware that the
nozzle of the torch
becomes very hot when in use.
Do not lift the
propane tank by the
valve.
SAFETY PUBLICATIONS RELATED TO
SAFE PRACTICE AND USE
IAS 2-94 US Requirements for
Hand Held LP Torches
for use with fuel
supply.
NOTICE
!

CAUTION

!
WARNING
ANSI Z49.1 Safety in welding and
cutting
NFPA 54 National Fuel Gas
Code
NFPA 58 Standard for the
storage and handling
of liquefied petroleum
gases
Assembly
GAS LINE TO TORCH
With the wrenches provided, assemble
gas line to torch handle. Use one
wrench to hold torch fitting so it does
not turn in the torch handle. Use the
other wrench to tighten gas hose
fitting onto handle fitting. The gas
fitting uses a left-handed thread. Turn
counterclockwiseto tighten. (See
Figure 2.)
GAS LINE TO CYLINDER
Insert hose fitting into gas cylinder
valve and turn counterclockwiseto
tighten. Use an adjustable wrench to
tighten the fitting. (See Figures 3 and
4.)
Lighting Instructions
1.Be sure gas valve on torch is closed
tightly — turn tight clockwise (see
Figure 5).
2.Open valve on propane cylinder and
check all components for leaks (use
soapy water or leak test solution).
DO NOToperate if
any leaks are
present. A leak may create a fire
hazard.
!
WARNING
Figure 2 - Attaching gas line to handle
(WT4500 shown, WT5500 similar)