Assembly, Ventilation, Tools Needed | Desa D30H, D44H, D20H guide

D20H, D30H AND D44H MODELS PORTABLE FORCED AIR HEATERS

ASSEMBLY

These models are furnished with wheels and handles. Wheels, handles, and the mounting hardware are found in the shipping carton.

TOOLS NEEDED

•Medium Phillips Screwdriver

•3/8" Open or Adjustable Wrench

•Hammer

1.	Slide axle through wheel support
	frame. Install wheels on axle.
	IMPORTANT: When installing wheels,
	point extended hub of wheels toward
	wheel support frame (see Figure 3).
2.	Place cap nuts on axle ends. Gently tap
	with hammer to secure.
3.	Place heater on wheel support frame.
	For D20H model, make sure outlet end
	(front) of heater is over wheels. For
	D30H and D44H models, make sure air
	inlet end (rear) of heater is over wheels.
	Line up holes on fuel tank ﬂange with

D20H Model	Sleeve Cap	Screw

	Hot Air
	Outlet	Handle

	Fuel	Air
	Tank
		Inlet
	Flange

Axle

Cap Nut

	Nut	Extended
	Nut	Hub
		Hub

Wheel

Front

HandleWheel Support

Frame

Screw

holes on wheel support frame.

4. For D20H model, place rear handle on

top of fuel tank flange. For D30H and

D44H models, place front handle and

rear handle on top of fuel tank ﬂange.

Insert screws through handle(s), fuel

tank ﬂange, and wheel support frame.

Attach nut ﬁnger tight after each screw

is inserted.

5. After all screws are inserted, tighten

nuts ﬁrmly.

Hot Air

Outlet

Fuel

Tank

Flange

Wheel

Support

Frame

WheelNut

Cap Nut

Rear

Handle

Air

Inlet

D30H and D44H Models

Extended

Axle Hub

VENTILATION

Figure 3 - Wheel and Handle Assembly

WARNING: Follow the mini- mum fresh, outside air ventilation requirements. If proper fresh, out- side air ventilation is not provided, carbon monoxide poisoning can occur. Provide proper fresh, out- side air ventilation before running heater.

Provide a fresh air opening of at least 2800 square cm (three square feet) for each 100,000 Btu/Hr rating. Provide extra fresh air if more heaters are being used.

Example: A 150,000 Btu/Hr heater requires one of the following:

•a two-car garage door [4.9 m (16 ft.) open- ing] raised 9 cm (3.5 inches)

•a single-car garage door [2.75 m (9 ft.) opening] raised 15.25 cm (6 inches)

•two, 76 cm (30 inch) windows raised 28 cm (11 inches)

105843