Desa Service Procedures, Upper Shell Removal, Fuel Filter, D20H Model, D30H and D44H Models

Page 8

D20H, D30H AND D44H MODELS PORTABLE FORCED AIR HEATERS

SERVICE

PROCEDURES

WARNING: Never service heater while it is plugged in, op- erating, or hot. Severe burns and electrical shock can occur.

UPPER SHELL REMOVAL

1.Remove screws and lock washers along each side of heater using 5/16" nut- driver. These screws attach upper and lower shells together.

2.Lift upper shell off.

3.Remove fan guard.

FUEL FILTER

(D20H Model)

1.Remove side cover screws using 5/16" nut-driver.

2.Remove side cover.

3.Pull rubber fuel line off fuel filter neck.

4.Carefully pry bushing and fuel filter out of fuel tank.

5.Wash fuel filter with clean fuel and re- place in tank.

6.Attach rubber fuel line to fuel filter neck.

7.Replace side cover.

Upper Shell

Upper

 

Shell

 

Fan

 

Guard

Fan

Guard

Figure 7 - Upper Shell Removal, D20H

Figure 8 - Upper Shell Removal, D30H

Model

and D44H Models

Fuel Filter

 

Side Cover

Fuel Line

Figure 9 - Fuel Filter Removal, D20H Model

FUEL FILTER

(D30H and D44H Models)

1.Remove side cover screws using 5/16" nut-driver.

2.Remove side cover.

3.Pull upper fuel line off fuel filter neck.

4.Carefully pry bushing, lower fuel line, and fuel filter out of fuel tank.

5.Wash fuel filter with clean fuel and re- place in tank.

6.Attach upper fuel line to fuel filter neck.

7.Replace side cover.

Fuel Filter, Bushing,

and Lower Fuel Line

Upper Fuel

Line

Side Cover

Figure 10 - Fuel Filter Removal, D30H and D44H Models

8

105843

Image 8
Contents Portable Forced AIR Heaters Safety Information D20H, D30H and D44H Models Portable Forced AIR HeatersProduct Identification Unpacking FuelsTools Needed AssemblyVentilation To Reset Heater Theory OperationTo Start Heater To Stop HeaterPreventative Maintenance Storing TRANSPORTING, or ShippingSchedule How Often How ToTroubleshooting Service Procedures Upper Shell RemovalFuel Filter D20H ModelDisconnecting Ignitor Wires from Ignition Control Assembly IgnitorPump Pressure Adjustment AIR OUTPUT, AIR INTAKE, and Lint FiltersNozzle Assembly Fuel and AIR Line Replacement Proper RoutingProcedure if Rotor is Binding Pump RotorSpecifications Wiring DiagramIgnition Control Assembly Procedure for Replacing FuseD20H Model Motor and Pump AssemblyIllustrated Parts Breakdown Parts List Number Description QTYD30H Model KEY Part Number Description QTY D44H Model D44H Model Desired partAccessories Ignition Control ASSEMBLY/PHOTOCELL Tester HA1170Wheels and Handles AIR Gauge KIT HA1180EC Conformity Declaration EC Conformity DeclarationWarranty Information