Desa CGP18C, RP30C installation manual Checking, Pressure Testing Heater GAS Connections

CHECKING	3.	Pressurize supply piping system by either using compressed air or
GAS		opening propane/LP supply tank valve.
	4.	Check all joints of gas supply piping system. Apply mixture of liquid soap and
CONNECTIONS		water to gas joints. Bubbles forming show a leak.
	5.	Correct all leaks at once.

Continued

Test Pressures Equal To or Less Than 1/2 PSIG

1.Close manual shutoff valve (see Figure 14).

2.Pressurize supply piping system by either using compressed air or opening propane/LP supply tank valve.

3.Check all joints from propane/LP supply tank to manual shutoff valve (see Figure 15). Apply mixture of liquid soap and water to gas joints. Bubbles forming show a leak.

4.Correct all leaks at once.

PRESSURE TESTING HEATER GAS CONNECTIONS

1.Open manual shutoff valve (see Figure 14).

2.Open propane/LP supply tank valve.

3.Make sure control knob of heater is in the OFF position.

4.Check all joints from manual shutoff valve to control valve (see Figure 15). Apply mixture of liquid soap and water to gas joints. Bubbles forming show a leak.

5.Correct all leaks at once.

6.Light heater (see Operating Heater, pages 17 through 19). Check the rest of the internal joints for leaks.

7.Turn off heater (see To Turn Off Gas to Appliance, page 19).

8.Replace front panel.

	Open
	Manual
	Shutoff
	Valve
	Closed
	Figure 14 - Manual Shutoff Valve
	Control Valve Location
	Propane/LP
	Supply Tank
	Manual
	Shutoff
	Valve
16	Figure 15 - Checking Gas Joints

101805