OWNER’S MANUAL
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place front log (#1) on top of the grate. Make sure the notches in the bottom of the log fits over the grate prongs (see Figure 17). Push back of log flush with metal grate bar.
2.Rest middle log (#2) behind metal posts on front burner. Make sure the grooves in the bottom of the log fit over the grate. Bring the log forward next to the metal posts. The cutout on the middle log must be on top (see Figure 18).
3.Slide the grooves in the back of the rear log (#3) against the rear grate prongs. Make sure the peg on the log is on top (see Figure 19).
4.Place the crossover log (#4) on the back log and the middle log. Make sure the peg on the rear log is in the hole in the bottom of the crossover log. The cross- over log should fit in the cutout of the middle log (see Figure 20).
Front Log (#1)
Notch
Grate
Prongs
Metal Grate Bar
Figure 17 - Installing Front Log (#1)
| Middle Log (#2) |
Groove | Groove |
| |
Metal |
|
Post |
|
Metal Post | Grate |
Figure 18 - Installing Middle Log (#2)
| Peg | |
Groove in | Rear Log (#3) | |
Back of | Groove in | |
Log | ||
Back of Log | ||
| ||
Grate Prong |
| |
Rear |
| |
Burner |
| |
| Grate | |
| Prong |
Figure 19 - Installing Rear Log (#3)
Crossover
Log (#4)
Hole
Cutout | 4 |
|
4 | Peg |
|
Figure 20 - Installing Crossover Log (#4)
104417 | 13 |