Nozzle, Removing Burner Head | Desa BV125EDI specs

Nozzle

1.Remove upper shell (see page 10).

2.Remove fan (see page 10).

3.Remove spark plug wire from spark plug.

4.Remove spark plug from burner head using 13/16" open-end wrench.

5.Loosen ﬂ are nut using 3/4" open-end wrench. Push fuel tube down.

6.Remove air line hose from burner head.

7.Remove three screws using 5/16" nut-driver and remove burner head from combustion chamber.

8.Place burner head into vise and lightly tighten.

9.Carefully remove nozzle from burner head using 5/8" socket wrench (see Figure 16).

10.Blow compressed air through face of nozzle. This will free any dirt in nozzle area.

11.Inspect nozzle seal for damage.

12.Replace nozzle into burner head. Tighten nozzle

ﬁrmly (80-110 inch- pounds/9.1-12.4 n-m).

13.Attach burner head to combustion chamber.

14.Install spark plug in burner head.

15.Attach spark plug wire to spark plug.

16.Attach fuel tube and airline hose to burner head. Attach ﬂ are nut until nut seats against fuel tube and

ﬁtting. Tighten 1/4 turn more using 3/4" open-end wrench (100-130 inch- pounds/11.3-14.7 n-m).

17.Replace fan (see page 10).

18.Replace fan guard and upper shell.

Combustion

Chamber

Burner Head

Screw

Air Line Hose

Flare Nut

Fuel Tube

Nozzle

Face

Nozzle

Seal

Nozzle

Burner

Head

Spark Plug Wire

Spark

Plug