ASSEMBLY
This heater is furnished with wheels, handles, and an interrupter. These items and the mounting hardware are found in the shipping carton.
Tools Needed
•Medium Phillips Screwdriver
•3/8" Open or Adjustable Wrench
•Hammer
1.Slide axle through wheel support frame. Install wheels on axle. IMPORTANT: When installing wheels, point extended hub of wheels toward wheel support frame (see Figure 2).
2.Place cap nuts on axle ends. Gently tap with hammer to secure.
3.Place heater on wheel support frame. Make sure air inlet end (rear) of heater is over wheels. Line up holes on fuel tank fl ange with holes on wheel support frame.
4.Place front handle and rear handle on top of fuel tank fl ange. Insert screws through handles, fuel tank fl ange, and wheel support frame. Attach nut fi nger tight after each screw is inserted.
5.After all screws are inserted, tighten nuts fi rmly.
6.Place interrupter onto combustion chamber. Secure with two screws. Save two additional screws for mounting vent pipe.
Hot Air | Screw |
Outlet |
|
Fuel
Tank
Flange
Wheel
Support
Frame
WheelNut
Cap Nut
Front Interrupter
Handle
Screw
Rear
Handle
Air
Inlet
Extended
Axle Hub
Figure 2 - Wheel, Handle, and Interrupter Assembly
5