Desa FVFM27NR installation manual Connecting to GAS Supply, Attaching Flexible Gas Hose to Heater

Page 11

OWNER’S MANUAL

INSTALLATION

Continued

7.Mark screw locations through one hole on each side of the mounting flanges (see Figure 12). If installing in a brick- bottom fireplace, mark screw locations in mortar joint of bricks.

8.Remove heater base from fireplace.

9.Drill holes at marked locations using 3/16" drill bit.

10.Attach base assembly to fireplace floor using two masonry screws (in hardware package).

11.Connect to gas supply. See Connect- ing To Gas Supply.

12.Replace logs on heater base.

Flexible Gas Fitting Hose (if allowed

by local codes)

Figure 11 - Attaching Flexible Gas Hose to Heater

Masonry Screw

CONNECTING TO GAS SUPPLY

WARNING: A qualified ser- vice person must connect heater to gas supply. Follow all local codes.

Installation Items Needed

Before installing heater, make sure you have the items listed below.

•piping (check local codes)

•sealant (resistant to propane/LP gas)

•manual shutoff valve *

•test gauge connection *

•sediment trap

•tee joint

•pipe wrench

*An A.G.A. design-certified manual shutoff valve with 1/8" NPT tap is an acceptable alternative to test gauge connection.

WARNING: Never connect heater to private (non-utility) gas wells. This gas is commonly known as wellhead gas.

CAUTION: Use only new, black iron or steel pipe. Inter- nally-tinned copper tubing may be used in certain areas. Check your local codes. Use pipe of 1/2" diameter or greater to allow proper gas volume to heater. If pipe is too small, undue loss of pressure will occur.

Installation must include a manual shutoff valve, union, and plugged 1/8" NPT tap. Locate NPT tap within reach for test gauge hook up. NPT tap must be upstream from heater (see Figure 13).

Apply pipe joint sealant lightly to male threads. This will prevent excess sealant from going into pipe. Excess sealant in pipe could result in clogged heater valves.

CAUTION: Use pipe joint seal- ant that is resistant to liquid pe- troleum (LP) gas.

Install sediment trap in supply line as shown in Figure 13. Locate sediment trap where it is within reach for cleaning. Locate sedi- ment trap where trapped matter is not likely to freeze. A sediment trap traps moisture and contaminants. This keeps them from going into heater controls. If sediment trap is not installed or is installed wrong, heater may not run properly.

CAUTION: Avoid damage to control. Hold gas fitting with wrench when connecting it to gas piping and/or fittings.

Mounting

Flanges

Figure 12 - Attaching Base Assembly to Fireplace Floor

A.G.A. Design-Certified Manual

Shutoff Valve With 1/8" NPT Tap

Approved Flexible Gas Hose (if allowed by local codes)

Gas Control

From Gas Meter (5" W.C.* to 10.5" W.C. Pressure)

Tee

Joint

3" Minimum

Pipe

Sediment

Figure 13 - Gas Connection

* Minimum inlet pressure for purpose of input adjustment.

Nipple Trap

Cap

Continued

105223

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Patent Pending Millivolt Remote Control Ready ModelFVFM27NR What to do if YOU Smell GASSafety Information Local Codes Product FeaturesRemote Control Accessories Product IdentificationConfined and Unconfined Space AIR for Combustion and VentilationProviding Adequate Ventilation Unusually Tight ConstructionDetermining if You Have a Confined or Unconfined Space AIR for Combustion VentilationDetermining FRESH-AIR Flow for Heater Location Ventilation Air From Outdoors Ventilation AIRVentilation Air From Inside BuildingLog Size Side Wall Ceiling InstallationCheck GAS Type Minimum Wall and Ceiling Clearances see FigureEration, If Using MantelIf Not Using Mantel Minimum Noncombustible Material ClearancesDetermining Minimum Mantel Clearance Determining Minimum Mantel Clearance When Using a HoodMantel Clearances Floor ClearancesArea of Various Standard Round Flues Installing Damper Clamp Accessory for Vented OperationInstalling Heater Base Assembly Installation Items NeededAttaching Flexible Gas Hose to Heater Connecting to GAS SupplyTest Pressures In Excess Of 1/2 Psig Pressure Testing Gas Supply Piping SystemPressure Testing Heater Gas Connections Checking GAS ConnectionsInstalling Bottom Log #1 Installing LogsInstructions For Your Safety Read Before LightingOperating Heater Optional Remote Operation Manual Lighting ProcedureTo Turn OFF GAS To Appliance Main Burner Inspecting BurnersPilot Flame Pattern Burner Primary AIR HolesObserved Problem Possible Cause TroubleshootingMaintenance, Observed Problem Possible Cause RemedyGas leak. See Warning statement at top TopTechnical Service Cleaning and MaintenanceSpecifications Service HintsWiring Diagram AccessoriesReplacement Parts FVFM27NR Illustrated Parts BreakdownDescription QTY Parts ListLimited Warranty VENT-FREE Natural GAS LOG Heaters Warranty Information

FVFM27NR specifications

Desa FVFM27NR is a modern and innovative product that embodies cutting-edge technology and design aesthetics, making it a standout choice in its category. This versatile device is tailored to meet the demands of consumers who seek both efficiency and performance in their daily activities.

One of the key features of the FVFM27NR is its robust build quality, which ensures durability and longevity. Constructed using high-grade materials, the device is designed to withstand regular use while maintaining a sleek appearance. This attention to detail not only enhances its functionality but also contributes to an appealing visual presence.

The FVFM27NR is equipped with advanced technologies that elevate its performance. With a powerful engine, the device delivers superior results across various applications. The incorporation of smart technology allows users to control and customize settings according to their specific needs, providing an intuitive user experience. Ergonomic design elements further enhance usability, ensuring that the device is comfortable to handle even during extended use.

Energy efficiency is another hallmark of the FVFM27NR. It integrates eco-friendly technologies that minimize power consumption without sacrificing performance. The energy-efficient operation not only reduces utility costs for users but also contributes positively to environmental sustainability.

Along with its efficiency and power, the FVFM27NR features a range of specialized modes that cater to different tasks. This versatility makes it suitable for various environments, whether in a home, office, or outdoor setting. The ability to switch between modes with ease allows for quick adaptation, making it a practical tool for users with diverse requirements.

Additionally, the FVFM27NR is designed with user safety in mind. It incorporates multiple safety features, including automatic shut-off and thermal protection, ensuring peace of mind during operation.

In conclusion, Desa FVFM27NR stands out as a leading option in its market segment, thanks to its combination of robust design, advanced technology, energy efficiency, versatility, and user safety. Whether for professional or personal use, it delivers exceptional value, making it an ideal investment for anyone seeking a reliable and effective device. With its modern features and characteristics, the FVFM27NR is well-positioned to meet contemporary lifestyle needs while ensuring optimal performance and satisfaction.
Top Page Image Contents