Desa REM200T owner manual Theory Operation, Extension Cord Wire Size Requirements, To Start Heater

OWNER’S MANUAL

THEORY OF

OPERATION

The Fuel System: The air pump forces air through the air line. The air is then pushed through the burner head nozzle. This air causes fuel to lift from the tank. A fine mist of fuel is sprayed into the combustion chamber.

OPERATION

WARNING: Review and un- derstand the warnings in the

Safety Information section, page

2.They are needed to safely op- erate this heater. Follow all local codes when using this heater.

EXTENSION CORD WIRE SIZE REQUIREMENTS

6 to 10 feet long, use 18 AWG rated cord

11 to 100 feet long, use 16 AWG rated cord

101 to 200 feet long, use 14 AWG rated cord

5. Plug extension cord into standard 120

volt/60 hertz, three-hole, grounded out-

The Air System: The motor turns the fan. The fan pushes air into and around the combustion chamber. This air is heated and provides a stream of clean, hot air.

The Ignition System: The electronic ignitor sends voltage to the spark plug. The spark plug ignites the fuel and air mixture.

The Flame-out Control System: This system causes the heater to shut down if the flame goes out.

TO START HEATER

1.Follow all ventilation and safety infor- mation.

2.Fill fuel tank with kerosene or No. 1 fuel oil.

3.Attach fuel cap.

4.Plug power cord of heater into three- prong, grounded extension cord. Exten- sion cord must be at least six feet long.

let. Adjust thermostat to desired setting.

If heater does not start, thermostat set-

ting may be too low. Turn thermostat

knob to higher position to start heater.

If thermostat is in HIGH position and

heater still will not start, push in flame-

out control reset button (see Figure 4).

Note: A cold heater may affect the ther-

mostat setting. This thermostat is a gen-

eral-heating control. It is not intended

for precise temperature control. Adjust

thermostat until heater cycles at the

desired setting.

			Motor	Air Pump
Combustion	Spark	Burner	Fan	Air
				Intake
Chamber
	Plug	Head		Filter
Clean				Cool
Heated				Air
Air Out				In

Air

Output

Filter

Fuel	Nozzle	Fuel	Air Line	Electronic
Tank		Filter	To Burner	Ignitor
	Air For Fuel		Air For Combustion	Fuel
	System		And Heating

Figure 3 - Cross Section Operational View

TO STOP HEATER

Unplug extension cord from outlet.

TO RESTART HEATER

1.Wait two minutes after stopping heater.

2.Repeat steps under To Start Heater.

Flame-out

Control

Reset

Button

Figure 4 - Flame-out Control Reset Button

106068 5