Sapphire Audio DV425TR owner manual LP Conversion Instructions

DV425TR DIRECT VENT ROOM HEATER

LP CONVERSION INSTRUCTIONS

Part #844-9010

KIT CONTENTS: Replacement orifice (fits top vent models only); replacement pilot injector.

1.Remove front (if installed), glass, and logs (if installed.)

2.Remove log/burner pan: First remove screws then lift the front of pan vertically and slide pan to one side and pull out of firebox. Fig. 1

3.Remove burner plate.

4.Pull off pilot hood and set aside. Fig. 2

5.Use a 5/32" Allen wrench to remove the pilot injector. Fig. 3

5.Replace pilot injector with the one supplied in the conversion kit (#35 for Propane, #62 for Natural Gas).

NOTE: The injector is ONLY replaced if you are con- verting to another gas. It is not replaced for a change from top to rear vent.

6.Replace pilot hood, snapping into position.

7.Remove main burner orifice using a 5/8" wrench.

8.Replace orifice with the proper size as indicated below for your gas type and venting: Fig. 4

	PROPANE	NATURAL GAS
Top Vent:	.063 (52 DMS)	.106 (36 DMS)
Rear Vent:	.059 (53 DMS)	.096 (41 DMS)

IMPORTANT NOTE! The orifice supplied with this conversion kit is for TOP VENT MODELS ONLY. If your stove was fitted with the rear vent kit, the correct conversion orifice was supplied WITH THE REAR VENT KIT.

See next page for Valve Regulator Replacement:

TOOLS REQUIRED: Power drill (a 90° handle is helpful); #2 Phillips bit; 5/32" Allen wrench; 5/8" open end wrench.

FIG. 1

Pilot Hood

FIG. 2	PILOT HOOD MILLIVOT GENERATOR
	THERMOCOUPLE

FIG. 3

FIG. 4

02/01 Page 13 250-5533