Sapphire Audio DV425TR owner manual Cathedral Ceiling Installation

DV425TR DIRECT VENT ROOM HEATER

VERTICAL INSTALLATION, cont.

CATHEDRAL CEILING INSTALLATION

Step 1.
Follow installation Steps 1 and 2 under
vertical termination section.	Figure 17
Step 2.
Using the plumb-bob, mark the centerline of
the venting system on the ceiling, and drill a small
hole through the ceiling and roof at this point. From
the roof, locate the drill hole and mark the outline of
the cathedral ceiling support box.

LEVEL

CATHEDRAL CEILING SUPPORT BOX

Step 3.

Remove shingles or other roof covering as necessary to cut the rectangular hole for the support box. Cut the hole 1/8” (3mm) larger than the support box outline.

Step 4.

Lower the support box through the hole in the roof until the bottom of the box protrudes at least

2” (51mm) below the ceiling (Figure 17). Align the support box both vertically and horizontally with a level. Temporarily tack the support box in place through the inside walls and into the roof sheathing.

Step 5.

Using tin snips, cut the support box from the top corners down to the roofline, and fold the resulting flaps over the roof sheathing (Figure 18). Before nailing it to the roof, run a bead of non-hardening mastic around the top edges of the support box to make a seal between it and the roof. Clean out any combustible material from inside the support box.

Step 6.

Complete the cathedral ceiling installation by following the same procedures outlined in steps 4 through 8 for vertical terminations.

CUT HOLE 1/8"

GREATER IN SIZE THAN PATTERN OF SUPPORT BOX AS IT IS PROJECTED ONTO ROOF LINE

Figure 18

2" MIN. BELOW FINISHED CEILING

02/01 Page 37 250-5533