Lighting Instructions

Sapphire Audio DV425TR owner manual Lighting Instructions, For Your Safety Read Before Lighting

DV425TR DIRECT VENT ROOM HEATER

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

A.This appliance has a pilot that must be lit manually. When lighting the pilot, follow these instructions exactly

B.BEFORE LIGHTING, smell around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explo- sion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

LIGHTING INSTRUCTIONS

1. STOP! Read the safety information above on this label.

2. Set the thermostat to the lowest setting (if applicable) and turn off the switch at the control panel.

3.Disconnect power from appliance.

4.Remove face and open the door of the appliance.

5.Wait five (5) minutes to clear out any gas. Smell for gas, including near the floor. If you smell gas, STOP! Follow “B” of the safety information above. If you don’t smell gas go to the next step.

6. Push gas control knob in and turn counter-clockwise	to pilot position. NOTE: Knob cannot be turned unless
knob is pushed in slightly. Do not force.

7.Press down on the gas control knob in pilot position and simultaneously press piezo igniter. (This may take many repetitions for lighting.)

8.The pilot should be visible through the door below the top log.

9.After the pilot is lit, continue holding control knob down for approximately 30 seconds. Release knob and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 6 through 8.

•If the knob does not pop up when released, stop and immediately call your service technician or gas supplier.

•	If the pilot will not stay lit after several tries, turn the gas control knob clockwise			to “OFF” and call your
	service technician or gas supplier.			Pilot Hood
10.	Push down and turn gas control knob counter-clockwise	to “ON”.		Pilot Hood


11.	Turn burner switch on the control panel to “ON”. If thermostat is to be used, Millivolt				Thermocouple
	leave switch in “OFF” position and set the thermostat to desired setting.		Generator		Thermocouple
			Generator

12.Re-install door and face.

13.Reconnect electrical power to appliance.

TOTURNOFFGASTOAPPLIANCE

1.Set the thermostat to lowest setting.

2. Push in gas control knob slightly and turn clockwise	to “OFF” position.
Do not force.


02/01	Page 47	250-5533

DV425TR specifications

The Sapphire Audio DV425TR stands out as an innovative and high-performance audio component designed for audiophiles and home theater enthusiasts alike. Featuring a sleek and modern aesthetic, the DV425TR encapsulates the perfect blend of advanced technology and premium materials, ensuring an exceptional listening experience.

One of the key features of the DV425TR is its exceptional digital-to-analog converter (DAC) technology. This cutting-edge DAC offers superior audio conversion capabilities, allowing for a wider dynamic range and a better signal-to-noise ratio. The result is crystal-clear sound reproduction that captures the nuances in recordings, whether it's a symphony orchestra or a simple acoustic guitar.

The DV425TR also comes equipped with high-resolution audio support, enabling playback of audio files up to 24-bit/192 kHz. This feature ensures that users can enjoy their favorite music in the highest quality possible, effectively bringing studio-level fidelity into the home environment. Additionally, the device supports various high-resolution audio formats, including FLAC, ALAC, and DSD, making it a versatile option for music lovers who appreciate quality.

In terms of connectivity, the Sapphire Audio DV425TR is built to accommodate the modern listener's needs. With multiple inputs, including optical, coaxial, and USB, users can seamlessly connect various audio sources, from CD players to computers. The unit also includes Bluetooth functionality, allowing for wireless streaming from smartphones and tablets, which adds convenience to the listening experience.

A significant highlight of the DV425TR is its custom-tuned internal amplifiers. These amplifiers are specifically designed to work in harmony with the DAC, ensuring that audio output is not only powerful but also enriched with depth and clarity. The carefully selected components contribute to a listening experience that is both engaging and dynamic, whether one is watching movies or enjoying music.

Another noteworthy characteristic of the DV425TR is its versatility in audio playback systems. It allows users to integrate the device into a variety of setups, including stereo, multi-channel, or home theater configurations. This adaptability makes it an ideal choice for those looking to enhance their audio systems without compromising on sound quality.

The Sapphire Audio DV425TR exemplifies the synergy of advanced technology and sophisticated design. With its impressive array of features, superior sound quality, and flexible connectivity options, it sets a new standard for home audio components, making it a must-have for serious audio enthusiasts.