Samsung VR20J9010UG/SP manual Charging Use

Page 18

Notes and cautions

Charging

In use

 

 

Note

 

 

Note

 

 

 

 

 

 

 

 

 

 

ffIf the battery overheats during charging, it may take longer to charge.

ffWhen automatic charging is not working, do the following:

––Turn the emergency switch (on the bottom of POWERbot) off and on again.

––Unplug the docking station's power plug and then plug it back on.

––Unplug the docking station, and then check whether there is any foreign matter on the charge pins and clean POWERbot and the charge pins of the docking station with a dry cloth or rag.

––Check for any obstacles such as reflective objects, chairs, etc. near the docking station.

ffIf POWERbot is left detached from the docking station, the battery will drain naturally.

––Try to keep POWERbot being charged on the docking station. (However, turn off the emergency switch and leave the docking station unplugged when planning to leave the house for long periods of time by going on a business trip or vacation, etc.)

ffThe POWERbot may get caught on thresholds, etc. during cleaning.

––To restart operation, shut off the emergency switch, move the POWERbot to an area where it can move easily, and then turn on the power again.

ffThe POWERbot cannot completely clean areas it cannot enter, such as corners, between the wall and sofa, etc.

––Please use another cleaning tool to clean them regularly.

ffThe POWERbot cannot vacuum clumps of dirt, so some may remain on the floor after cleaning.

––Please use another cleaning tool to clean them regularly.

ffIf the battery becomes low during Auto clean mode, POWERbot will recharge and finish cleaning the remaining area after recharging. (Repeat cleaning frequency: 1 time)

ffYou cannot select and have the POWERbot execute Spot/Manual clean mode while it is charging.

ffDo not unnecessarily move the POWERbot or press buttons while it is in Auto clean mode. It assumes that cleaning is complete and starts cleaning again from the beginning.

ffClose doors before cleaning with the POWERbot. The POWERbot can enter rooms through thresholds even though the thresholds are below 5 cm.

ffTry not to use the POWERbot at areas near slides, indoor swing, pots, fireplaces, or places with flame or moisture.

–– If not, it may cause the loss of property.

ffDo not lie down around the POWERBOT that is running.

––Your hair may be caught in the power brush, resulting in physical injury.

ENGLISH-18

Image 18
Contents POWERbot Charging Safety information InformationIndicates a detachable supply unit General ENGLISH-05 ENGLISH-06 ENGLISH-07 Installation Accessories 1Turn on the emergency switch on the bottom ChargingCheck the installation status of the docking station when Manually charge the POWERbot whenSR20J90U Series Using POWERbotPress Button for more than Seconds SR20K9000U SeriesAuto clean Spot clean SR20J90U Series Manual cleanUsing the remote control Power/RechargingBottom Name of each partTop Display panelCleaning and maintaining Cleaning the dustbinCleaning the sensors and the camera Remove the Power Clean the Power brush Brush cover Cleaning the Power brushCleaning the Driving wheel Reassemble the Power Brush Brush coverCharging Use Cleaning and maintenance About the batteryInformation codes Troubleshooting Symptom ChecklistOpen Source Announcement Specifications Detail informationThis product is RoHS compliant