Samsung WD7122CZS/YKJ manual Water supply hose

Installing the Washing Machine

Connecting the water supply hose

1. Remove the adaptor from the water supply hose.

2.	First, using a‘+’ type screw driver, loosen the four screws on the adaptor.
	Next, take the adaptor and turn part(b) following the arrow until there is a
	5mm gap.
3.	Connect adaptor to the water tap by tightening the screws firmly.
	Then, turn part (b) following the arrow and put(a) and (b) together.
		a
		b
4.	Connect the water supply hose to the adaptor. Pull down part (c) of the
	water supply hose.
	When you release part (c) the hose automatically connects to the adaptor
	making a‘click’ sound.		c
5.	Connect the other end of the water supply hose to the inlet water valve at
	the top of the washer.
	Screw the hose clockwise all the way in.
•	If the water tap has a screw type faucet, connect the water supply hose to
	the tap as shown.

Notice :

•After completing connection, if water leaks from the hose, then repeat the same steps. Use the most conventional type of faucet for water supply. In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.

•The appliance is to be connected to the water mains using new hose-sets and that old hose-sets should not be used.

SAMSUNG Washing Machine Owner’s Instructions A-4

WD7122CZ-02540K_EN.indd 4

2008-08-13 ¿ÀÀü 9:36:40