Samsung WD7122CZS/YKJ manual Using Dry course, Using delay

Page 16

Washing a Load of Laundry

Using Dry course

Refer to the label of drying capacity and be sure to put in the clothes to the lower level than the marked line for the dried clothe of 6.0kg.

1.Open the door, put in the clothes and close the door again.

2.Press the POWER button and then press the Dry button.

: The cotton course will be selected automatically.

Drying is availably selected only at the courses such as Towel, Cotton, Boil, Eco-Boil, Intensive and Quick.

3.Select Dry button as follows.

: Every press of this button will select drying type repeatedly in the following order:

Cupboard Extra Iron Light Time (30 min 1:00 min 1:30 min 2:00 min 2:30 min)

Cupboard

It automatically displays Drying Time by sensing the weight of clothes before drying for increasing the drying effect.

4.Put suitable amount of detergent and fiber softener in the detergent tray and close it again.

5.Press Start/Pause button.

: It automatically performs an optimal function from washing to drying.

Notice :

The selected course can’t be altered after the start of drying.

If you select Drying function, the intensity of SPIN will be set up as High in default for increasing the drying effect.

If cold water is not supplied, drying will not be performed.

If you do not take out clothes from the tub after the end of drying, a function of wrinkle protection will be performed for about 30 minutes with the display of [End].

In order to take out the clothes: press firstly PAUSE or POWER button and take them out.

In case you wish to dry after hand washing, select both SPIN and Drying at the same time.

Using delay

You can set the washing machine to finish your wash automatically at a later time, choosing up to 24 hours maximum (in one hour increments). Displayed hours means the time of finished washing-cycle.

To do this:

1.Manually or automatically set your washing machine for the type of clothes you are washing.

2.Press the Delay Start button repeatedly until the delay time is set.

3.Press the Start/Pause button. The Delay Start indicator will light, and the clock will begin counting down until it reaches your finish time.

4.To cancel Delay Start, press the Power button, then turn the washing machine on again.

B-6 SAMSUNG Washing Machine Owner’s Instructions

WD7122CZ-02540K_EN.indd 6

2008-08-13 ¿ÀÀü 9:36:48

Image 16
Contents Washing Machine Owner’s Instructions WD7122CZ-02540KEN.indd 2008-08-13 ¿ÀÀü Features Washing to drying with one buttonBefore using the appliance Safety PrecautionsSafety instructions Table of Contents Unpacking the washing machine Installing the Washing MachineOverview of the washing machine Selecting a location Adjusting the leveling feetRemoving the shipping bolts Connecting the water supply hose To connect the water supply hoseWater supply hose Positioning the drain hose Over the edge of a wash basinWashing a Load of Laundry Washing for the first timePutting detergent in the washing machine To do thisOverview of the control panel Air wash ButtonStop&Add selection button How to Set up For the silver wash washingChildlock button lock function Washing clothes manuallyWashing clothes using Fuzzy Logic To wash clothes using the Fuzzy Logic programsWhen the cycle is finished Pause OptionUsing Dry course Using delayUsing Clean Tub To Add LaundryWashing tips and hints Fabric Type Load CapacityRepairing a frozen washing machine Cleaning the exteriorMaintaining the Washing Machine Draining the washing machine in an emergencyCleaning the detergent drawer and recess Cleaning the debris filterCleaning the water hose mesh filter Troubleshooting Problems and solutionsUnderstanding error messages Before contacting After-Sales serviceProgramme Chart  user optionAppendix Fabric care chartElectrical warnings Declaration of conformity Protecting the environmentSpecification Memo Memo WD7122CZ-02540KEN.indd 2008-08-13 ¿ÀÀü
Related manuals
Manual 14 pages 60.64 Kb