Samsung WF80F5E5U4W/KJ manual Connecting the drain hose

Connecting the hot water supply hose (selected models)

1.Connect the red L-shaped arm fitting for the hot water supply hose to the hot water supply intake at the back of the washing machine. Then tighten it by turning part (A) clockwise by hand.

2. Connect the other end of the hot water supply hose to your sink’s	A
hot water tap in the same way as you connected the cold water
supply hose.

To use only cold water, use the Y-piece.

Connecting the aqua hose (selected models)

The aqua hose was invented to ensure perfect leakage protection.

The aqua stop is attached to the aqua hose and automatically cuts the water flow if the hose is damaged.

It also displays a warning indicator (A) on the aqua stop.

Connect the aqua hose by assembling the aqua stop on the tap as shown.

A

Connecting the drain hose

The end of the drain hose can be positioned in three ways:

Over the edge of a wash basin

The drain hose must be placed at a height between 60 cm and 90 cm.
To keep the drain hose spout bent, use the supplied plastic hose guide
(A). Secure the guide to the wall with a hook or to the tap with a piece
of string to prevent the drain hose from moving.	A
(*): 60 ~ 90 cm

ln a sink drain pipe branch

The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60 cm above the ground.

ln a standpipe

We recommend using a 65 cm high vertical pipe as a standpipe. It must be no shorter than 60 cm and no longer than 90 cm. To keep the drain hose spout bent, use the supplied plastic hose guide (A). Secure the drain hose to the standpipe with tie straps to prevent the drain hose from moving.

The standpipe drain requires:

•A minimum diameter of 5 cm.

•A minimum carry-away capacity of 60 litres per minute.

(*): 60 ~ 90 cm

Setting up your washing machine

19

Untitled-1 19

2013-04-30 �� 3:09:49