Samsung RF220NCTAWW/ML manual Automatic Ice Maker does not work, Temperature Indicator moving

Before calling service

If you have further questions or damaged accessory parts, contact us at 1-800-SAMSUNG (726-7864)

1. Automatic Ice Maker does not work

• Allow your refrigerator to operate and cool down		12
for 24 hours (1 full day) before the ice maker starts	9	3
producing ice.		6

Temperature Indicator moving)

•

refrigerator not to generate cool air. (Only for product sold in U.S)

[RF221, RF220]

①①

[RL225]

①①

[RL220]

•Do not use copper line.

•Cut the tubing, making sure the ends are square and clean.

IncorrectCorrect

There are several items that you need to purchase to complete this connection.

You may fi nd these items sold as a kit at your local hardware store.

Use Copper Tubing	Use Plastic Tubing
¼” copper tubing	¼” plastic tubing Molded end
¼” compression nut (1pc)	(Bulb)
Ferrule (2pc)	¼” compression nut (1pc)

4. Fridge or freezer Compartments are warm

•Allow your refrigerator to operate and cool down for 24 hours (1 full day) to reach to the set temperature.

•Also, into your refrigerator, it may need an additional 24 hours for the fridge to reach the set temperature.

( 1 )	Press the Freezer button to set the freezer temperature
	between colder and coldest.
Freezer
	Press and hold the Freezer button for 3 seconds to activate
(Hold 3 sec for
	Power Freezer function which speeds up the freezing
Power Freeze)
	process in the freezer.
( 2 )	Press the Fridge button to set the Fridge temperature
Fridge	between colder and coldest.
( 3 )	For better energy effi ciency, press the Energy Saver button.
	If condensation occurs on the doors, turn the Energy Saver
Energy Saver
( 4 )	button. The LED will light up and the Ice-Maker stops
	making ice.
( 5 )
( 6 )	Press this button to activate Power Freezer function which
Power Freeze	speeds up the freezing process in the freezer.

8. Food stored in refrigerator is frozen

•If food with too much moisture is stored near the cooling vents, it may get frozen. Be sure to keep moist food away from the cooling vents.

①①

5. Moisture forms on outside/inside of refrigerator 9. Moving and Installing

•

but it does not make cool air. To cancel this mode, press the “Cooling O Key” at the same time for 5 seconds until “Ding-dong” sounds.

COOLING OFF KEY

-

RL220- Model : Power Freeze + Freezer Key

3. Water dispenser Intallation(On some models)

•Turn on water installation and Flush 3 gallons through fi lter before use (fl ush approximately 6 minutes)

•

hot and humid seasons.)

•

Saving function.

•If you open the doors frequently or for too long, it may cause moisture inside the fridge.

6. Noise Clicks, Pops, Cracks, Snaps

• These noises may be heard occasionally inside the refrigerator.

This is normal. This sound occurs when various items contract

or expand while temperatures are changing; especially during

defrosting. This may also occur when electronic devices including

•When installing, servicing or cleaning behind the refrigerator, be sure of the following:

• To protect your fl oor’s fi nish when moving the refrigerator, cut a large section of the cardboard carton and place under the refrigerator where you are working.

• Pull the unit straight out and push

back in straight after fi nishing.

10.Leveling & Door Alignment

90 degree

1. Cold Water line

2. Pipe Clamp.

3. Plastic line

4. Compression Nut

5. Compression Sleeve

6. Packing Nut

8. Filter Cartridge

9. Cartridge Holder

the ice maker are operating.

7. Display

[RF221, RF220]

1 2 3

• Insert a fl at-blade screwdriver into a slot on the control lever, turn it clockwise or counter- clockwise to level the door.

ControlLever

Flat-blade screw driver(-)

• The water fi lter must be installed outside the refrigerator. It is not provided with your new refrigerator. The fi lter cartridge (8) and holder (9) kit can be purchased from local

.hardware store.

[RL225]

4 5

[RL220]

6

DA68-02659A REV(0.0) ENGLISH

DA68-02659A.indd 1 2012.6.27 12:7:25 PM