Wall Installation

HCE-1201

Tools needed for easy installation: Philips Head Screwdriver, Drill, 1/8” drill bit, Ruler, and a Level

•For installation of the wall heater you will need the following parts that are included with the heater: 2 anchors and 2 screws

•The location must be situated safely above running water and approximately 1 foot to the left or right of an electrical outlet. For safety reasons, never mount any appliance directly above or below an electrical outlet.

•Using a 1/8 drill bit, drill a hole 1 ½ ” deep and insert one anchor.

•Measure 11 1/8 ” from the center of the installed anchor mark the spot for your 2nd hole. Use a Level to make sure the holes are the same height.

•Using the 1/8 drill bit, drill your second hole 1 ½ ” deep on your mark and insert the other anchor in the 2nd hole.

•Hang your heater from the screws by lining up the large openings on the bottom of the heater and pushing the heater to the right and then down in one motion. The heater should now be securely against the wall and is ready to be plugged in.

Note: If the top of the heater is not secure against the wall, take the heater off the wall, tighten the screws a few turns and mount it again.

2 fixing holes

11 1/8˝

Floor

	hole for fastening	Screw
	to the wall	Screw
	to the wall

Fig. 4

Wall

hang up

Fig. 2	Fig. 3	Body base	Fig. 5