Using attachments Cleaning the filters

8537 Upright Currys cyclone ib 12/05/2003 18:13 Page 5

Using attachments

Cleaning the filters

Follow previous steps 1-4 but set the carpet height adjustment knob to the deep carpet setting.

5Remove the hose connector from the rear of the cleaner and push the required attachment firmly onto the end of the hose.

•If additional length is required, attach one or both extension tubes between the hose and tool.

6Switch on/off.

IMPORTANT: Never over extend the hose

such that the cleaner is pulled over.

Emptying the dust canister F

When the dust canister is full it should be emptied immediately.

To maintain suction, the filters must be regularly taken out and cleaned. Failure to clean the filters will reduce the suction and will damage the motor if used for prolonged periods. This may invalidate the guarantee. If the filters become damaged they must be replaced.

IMPORTANT: Do not operate the cleaner without the filters in place.

Circular pleated & foam filters G

IMPORTANT: The filters should be cleaned regularly to maintain the performance of the cleaner.

1Remove the front cover and the canister.

2Twist the canister lid Ï anti-clockwise and lift off.

3Lift up the pleated circular filter Ì and foam filter Ó beneath. The filters can be cleaned using the brush Û clipped inside

1Remove the front cover ‹ by lifting the cover release lever ¤.

2Lift-up the dust canister release Î and pull the canister away from the main body.

3Hold the canister by the handle Ù over a dustbin and with your other hand press the dust release button Ò. The bottom of the canister will drop down to release the dirt. To close press the flap firmly until it clicks into place.

4Replace the canister by inserting the base then pushing in the top. Replace the front panel by aligning the bottom tabs with the slots in the body, then pressing in the top.

ÛÏ

‹	Ù