DRAINING THE UNIT
During the cooling process, some water will be extracted from the air and stored within the unit’s water reservoir.
If the water reservoir is full, both the compressor and motor will stop and the unit will beep (press any button to stop the beeping sound). The full water tank indicator light will also start flashing.
To resume cooling, empty the reservoir by following these steps:
1.Turn off the air conditioner and unplug it from the wall socket. To prevent water leakage, avoid moving the unit when full.
2.Place a container (such as a small pan) underneath the drainage port.
3.Remove the water plug from the drainage port and allow the water to drain out.
4.When the container is almost full, replace the water plug back into the drainage port
| and empty the water container. | Water plug |
5. | Repeat until the water reservoir is | Cap for the |
| completely empty. | water plug |
6. | Replace the water plug back into the | Drainage port |
| drainage port and make sure it is firmly in | FIG.17 |
| place. |
|
7.Turn the unit back on. The warning signal should be off.
For Continuous Drainage
•Remove the water plug from the drainage port and retain it for future use.
•Connect the drainage hose included with unit to the drainage port as shown. Connect the other end of the hose into a drain.
FIG.18
Water plug
Cap for the water plug
10