Miele S185 Replacing Parts, HOW to Replace Drive Belt, S01Z6000 and Beater BAR Assembly R98M9064

REPLACING PARTS

Use only genuine Miele replacement parts.

DISCONNECT THE CLEANER FROM THE ELECTRICAL SUPPLY.

If you have any questions, contact your local dealer / service agent.

Any service needed other than described in these Operating Instructions should be performed by a Miele Service Center only.

To replace any of the following parts, place the vacuum cleaner in the horizontal position by using the pedal. Then turn it over exposing the underside.

HOW TO REPLACE - DRIVE BELT

(Part # S01Z6000) AND BEATER BAR

ASSEMBLY (Part # R98M9064)

1. Remove the 5 screws from the base plate and lift it off. (Fig. 1)

2.Release the belt from the motor shaft and lift the beater bar assembly to remove the belt. (Fig. 2)

3.To reassemble the beater bar assembly,

simply return the belt to the motor shaft and beater bar pulley.

Re-insert the bar mounts into their holders, and turn the beater bar to ensure that the belt has been seated correctly. (Fig. 3)

IMPORTANT: Make sure the belt is correctly positioned in the selector lever.

4.Replace the base plate and re-fasten the screws securely.

HOW TO REPLACE - BEATER BAR /

SIDE BRUSHES / BEARING SUPPORT A-B

1. First remove the base plate, drive belt and lift out the beater bar assembly (as illustrated above).

2. Remove the 2 screws at both ends of the

beater bar assembly and separate the2 different parts as shown in the exploded view.

3.Replace any damaged part and reassemble in reverse order.

HOW TO REPLACE HEADLIGHT BULB

1. Loosen the 2 screws from the lens cover and remove it. (Fig.1)

2. Remove the old bulb by simply pulling it forward, and replace it with a new one. (Consult your local dealer /Service agent for a suitable bulb) (Fig. 2)

3) Replace the lens cover and re-fasten the screws securely

Fig. 2

Fig. 1 Fig. 3

1 - Beater bar

2 - Side brush B

3 - Side brush A

4 - Bearing support A

5 - Bearing support B

4

1

5

3

Fig. 1 Fig. 2

– 10 –