H) HOW TO USE THE ACCESSORIES
1)To use the accessories always keep the vacuum cleaner in the upright position.
2)Pull out the hose from the suction pipe inlet and remove it from the hose clip. Then slide the hose through the hose support and connect any accessory as illustrated below.
Important: For a longer reach, remove the hose support from its fastening and hold the handle of the cleaner with one hand to avoid pulling the cleaner over.
NOTE:After finishing with the accessories,
Hose clip
Hose support
| STO |
STO | BEATE |
| BAR |
BEATE | ON |
BAR | |
ON |
|
Suction pipe inlet
CAUTION While using the accessories, hold the handle of the cleaner with one hand, as shown above, to avoid
pulling the cleaner over.
Crevice nozzle |
| Dusting brush |
| Upholstery nozzle | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
I) BAG CHECK INDICATOR
The bag change indicator is a visual aid to | Green mark | Red mark |
advise you of the condition of the dust bag. |
|
|
The GREEN mark indicates that the dust bag is |
|
|
still empty. |
|
|
The RED mark will appear when airflow through |
|
|
the bag is insufficient. When this happens, check |
|
|
the dust bag, it may be full or blocked with fine |
|
|
dust and needs replacing. |
|
|
NOTE: If after replacing the bag, the RED indicator still appears in the window, check to see if the hose or suction inlet is clogged. (see BLOCKAGES).
When using the crevice nozzle the red mark may appear. This is due to reduced air flow and not an indication that the bag is full.
– 7 –